Many medical device manufacturers currently incorporate accessible features in some of their products such as patient support surfaces that are height adjustable, transfer and positioning...
Search Results "Ramp Surface"
Filters
Commonly Searched Documents
-
Medical Device Manufacturers
-
§ 37.42(c)(3)
(3) Bridge plates, ramps or other appropriate devices;...
-
§ 37.42(c)(3)
(3) Bridge plates, ramps or other appropriate devices;...
-
1009.2.1 Elevators required
buildings equipped throughout with an automatic sprinkler system installed in accordance with Section 903.3.1.1 or 903.3.1.2, the elevator shall not be required on floors provided with a ramp...
-
d) Paving Guidelines
The City's Paving Guidelines permit the City to defer curb ramp installation for a period of up to twenty-four months in cases where there is a pre-planned project that would require demolition...
-
OTHER SPECIFIC BARRIERS
Exhibit A to this Complaint identifies missing and Inaccessible curb ramps at various locations within the City's pedestrian right of way....
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters or Other Mobility Aids
Where ramps are used, they cannot be steeper than 1:12. Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Detectable Warnings [§406.8 (DOT’s Standards), §705]
Detectable Warnings [§406.8 (DOT’s Standards), §705] Detectable warnings are required on curb ramps at transit facilities covered by DOT’s Standards (facilities used by state and...
-
Background
This is especially the case with issues related to surfaces....
-
Data Collection Procedures
Within a maximum of one month from each surface installation, a preliminary accessibility assessment of the trail surface was conducted and the surfaces were tested for firmness and stability...
-
11B-406.6 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
Suggestions by Jean Tessmer
Suggestions by Jean Tessmer As published in Concrete Technology Today, April 2001, Jean Tessmer, accessibility consultant for Space Options, suggested that ramp slopes be measured with...
-
[2010 ADAS] 105.2.3 ASTM
ASTM F 1292-99 and ASTM F 1292-04 establish a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and...
-
ASTM
ASTM F 1292 establishes a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and around playground equipment...
-
WALK
[DSA-AC] An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts. (As differentiated from the definition of “Sidewalk”.)...
-
11B.707.7.1.2 Angle-mounted display screen
viewer 30 degrees to less than 60 degrees from vertical, the center line of the display screen and other display devices shall be no more than 44 inches (1118 mm) above the floor or ground surface...
-
RESEARCH OBJECTIVES
Objectively measure the firmness and stability of the test surfaces; 3....
-
11B-505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
Facility
It is helpful to remind staff to keep that area free of equipment and clutter. 902 Dining Surfaces and Work Surfaces. 902.2 Clear Floor or Ground Space....
-
Q2.) What are the types of “field conditions” that were anticipated where the advisory says “tolerances recognized by this provision include those for field conditions”?
And a concrete finisher clearly cannot guarantee that the slope of a concrete curb ramp will be consistently 8.33% across its entire surface. ...
-
Dome Spacing: ADA Standard Section 705.1.2
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 1.6 inches (41 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
11B-307.3.1 Edges and corners
Where signs or other objects are mounted on posts or pylons, and their bottom edges are less than 80 inches (2032 mm) above the floor or ground surface, the edges of such signs and objects...
-
4.29.3* TACTILE WARNINGS ON DOORS TO HAZARDOUS AREAS
to areas that might prove dangerous to a blind person (for example, doors to loading platforms, boiler rooms, stages, and the like) shall be made identifiable to the touch by a textured surface...