When the reach is over a kitchen work surface and base cabinet, the work surface shall be 36 inches (914 mm) maximum above the finish floor and 25 1/2 inches (650 mm) maximum in depth....
Search Results "Check Writing Surface"
-
11B-809.12 Electrical receptacles, controls and switches
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
T402.8.2 Deployment to Boarding Platforms
The running slope of ramps and bridgeplates used for deployment to platforms shall be 1:8 maximum, as measured to the boarding platform with the non-rail vehicle resting on a flat surface...
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-705.1.2.1 Platform edges
Detectable warning surfaces at platform boarding edges shall be 24 inches (610 mm) wide and shall extend the full length of the public use areas of the platform....
-
Literature Review
The first review of the literature focused on the effects of surface roughness on the health and safety of WC riders....
-
11B-609.4 Position of grab bars
Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface, except...
-
Emphasis on Limitations Instead of Outcomes
, someone with a learning disability may achieve a high level of academic success, but may nevertheless be substantially limited in one or more of the major life activities of reading, writing...
-
4.29.7* STANDARDIZATION
Textured surfaces for tactile door warnings shall be standard within a building, facility, site, or complex of buildings....
-
Garage Parking
At sites that also include surface lots, a garage is treated as a separate parking facility for scoping purposes....
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
May I ask an individual what his or her disability is?
You may ask (by writing a note if necessary), “Do you need me to notify you if I make any announcements over the public address speaker?”...
-
James L.E. Terry, A.I.A., Principal Trainer
He has led the writing of several books on access standards and ADA Facilities Compliance, led the ADA revision of Architectural Graphic Standards 9th Edition, initiated the development...
-
Alternate formats (Preamble, Section-by-Section Analysis)
ASCII refers to the American Standard Code for Information Interchange, which is an American National Standards Institute (ANSI) standard defining how computers read and write commonly used...
-
Words
When writing or speaking about people with disabilities, it is important to put the person first....
-
§ 38.83(c)(8) Handrails
them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp surface...
-
§ 38.125(c)(8) Handrails
grasp them from outside the car while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp surface...
-
8. Report
Measurements—Data from the profile measuring process shall include the date and time of day of the measurement, the location of the measurement, length of measurement, and the descriptions of the surface...
-
11B-1009.2.4 Seat
The height of the lift seat shall be designed to allow a stop at 17 inches (432 mm) minimum to 19 inches (483 mm) maximum measured from the deck to the top of the seat surface when in the...
-
4.34.6.5(8)
(8) There shall be no sharp or abrasive surfaces under sinks. Hot water and drain pipes under sinks shall be insulated or otherwise covered. Figure 51 Kitchen Sink...
-
11B-405.9.2 Curb or barrier
or barrier shall be provided that prevents the passage of a 4 inch (102 mm) diameter sphere, where any portion of the sphere is within 4 inches (102 mm) of the finish floor or ground surface...
-
11B-705.1.1.3 Color and contrast
Detectable warning surfaces shall comply with Section 11B-705.1.1.3.1. The material used to comply with this section shall be an integral part of the detectable warning surface....
-
Communicating With Individuals Who Are Deaf or Hard of Hearing
Use writing only for brief encounters: Exchanging written notes can be used for brief encounters when an interpreter is not available, but should not be relied on for any kind of in-depth...
-
505 Handrails
505 Handrails The 2010 Standards add a new technical requirement at section 406.3 for handrails along walking surfaces....