Defendants shall make all architectural modifications in compliance with the ADA and its implementing regulation and the 2010 ADA Standards for Accessible Design (“Standards”). ...
Search Results "FTDS: Federal Trail Data Standards"
Filters
Commonly Searched Documents
-
V. ACTIONS TO REMEDY NONCOMPLIANCE WITH ACCESSIBILITY REQUIREMENTS
-
28 CFR Parts 35 and 36, Nondiscrimination on the Basis of Disability by State and Local Governments and Places of Public Accommodation; Equipment and Furniture (ANPRM)
Written comments must be postmarked and electronic comments must be submitted on or before [INSERT DATE 180 DAYS AFTER DATE OF PUBLICATION IN THE FEDERAL REGISTER]....
-
222 and 803 Dressing, Fitting, and Locker Rooms
The requirements for alterations in the 2010 Standards at section 202.3 do not include the requirement from the 1991 Standards at section 4.1.6(1)(c) that if alterations to single elements...
-
5.0 Conclusions
The U.S. standards are in more need of change but the basis for many of the changes previously made to the standards in Canada, the U.K. and Australia can also be questioned in light of...
-
11B-407.2.2.1 Visible and audible signals
[2010 ADA Standards] 2. In existing elevators, a signal indicating the direction of car travel shall not be required....
-
PRIVATE BUILDING OR FACILITY
[2010 ADA Standards 106.5] Private Building or Facility....
-
11B-407.2.1.1 Height
[2010 ADA Standards] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
11B-407.4.6.2.1 Size and shape
[2010 ADA Standards] 407.4.6.2.1 Size. Buttons shall be ¾ inch (19 mm) minimum in their smallest dimension....
-
SafePath: ADA Entry Level Landing Installation Training Video
This is required by federal law and by local access and building codes....
-
National Rehabilitation Information Center (NARIC)
community, NARIC's Web site continues this tradition by putting the information into the hands of the users through online publications, searchable databases, and timely reference and referral data...
-
Philips Healthcare
Access Board Federal Medical Diagnostic Equipment Accessibility Standards Advisory Committee BALLOT ON COMMITTEE REPORT This Ballot is due to the Access Board by October 11th, 2013...
-
202.3.1 Prohibited Reduction in Access
Justice regulations 28 CFR 35.133 for public entities (Title II) and 28 CFR 36.211 for private entities (Title III) clarify that reduction of accessibility is benchmarked to the 2010 ADA Standards...
-
Toilet Rooms North (Celebrity Spies)–Women [sic]
See Standards § 4.13.11(2)(b). gg. The women's toilet room stall door hardware requires tight grasping and twisting of the wrist. See Standards § 4.13.9. hh....
-
Required Compliance [§210]
Required Compliance [§210] Interior and exterior stairs that are part of a required means of egress must meet the Standards....
-
11B-224.7.2 Multi-bedroom housing units with adaptable features
Access Board's Note to Reader: The Department of Justice’s ADA standards also require the following: Housing at a place of education. ...
-
§ 1194.2(b)
Agencies cannot claim a product as a whole is not commercially available because no product in the marketplace meets all the standards. ...
-
§40.3(a)
(a) The standards prescribed in §40.4 are applicable to residential structures designed after the effective date of this part....
-
C. REMEDIAL ACTION
Standards 4.1.2(1), (2) and 4.3. Patient Rooms 26....
-
11B-206.2.4 Spaces and elements
[2010 ADA Standards] 1....
-
11B-610.3 Shower compartment seats
A seat in a standard roll-in shower compartment shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back wall to a point within...
-
§ 36.304(g)(2)
(2) To the extent that relevant standards for alterations are not provided in subpart D of this part, then the requirements of §36.304 shall not be interpreted to exceed the standards for...
-
Allegion Falcon B-Series Mechanical Locks
All lever designs shall be solid (no inserts) and meet the federal ADA and state disability requirements. Locksets shall adjust to fit door thickness from 1 3/8” to 2”....
-
Picnic Tables
If the picnic tables are provided on trails, ensure the routes connecting them to any other major constructed features in the area comply with the technical requirements for trails....
-
Valet Parking and Mechanical Access Parking Garages
The 1991 Standards, at sections 4.1.2(5)(a) and (e), and sections 208.2, 209.4, and 209.5 of the 2010 Standards require parking facilities that provide valet parking services to have an...
