The ADA Accessibility Guidelines (ADAAG) is the standard applied to buildings and facilities....
Search Results "FTDS: Federal Trail Data Standards"
Filters
Commonly Searched Documents
-
Introduction
-
Introduction
The ADA Accessibility Guidelines (ADAAG) is the standard applied to buildings and facilities....
-
Introduction
The ADA Accessibility Guidelines (ADAAG) is the standard applied to buildings and facilities....
-
Rulemaking History
On February 22, 1991, the Department of Justice published a notice of proposed rulemaking (NPRM) implementing title III of the ADA in the Federal Register. 56 FR 7452....
-
Additional Information
relative to a primary baseline scenario (1991 Standards)....
-
7.4. Costs to Impacted Small Entities
Annual revenue data from the U.S....
-
NuStep T5 Recumbent Cross Trainer
Easy to use 15 levels of resistance Easy startup with no button press required Push button workload control Comprehensive data readouts Goal setting...
-
106.5.66 Structural Impracticability
In new construction, full compliance with the requirements of these standards is not required where an entity can demonstrate that it is structurally impracticable to meet the requirements...
-
Toilet Rooms-Special Exhibit Space
See Standards § 4.13.11(2)(b). v....
-
202.4 Alterations Affecting Primary Function Areas
hardware, controls, electrical outlets, and signage shall not be deemed to be alterations that affect the usability of or access to an area containing a primary function. 2010 ADA Standards...
-
SCOPE OF THE INVESTIGATION
. § 35.151, and the ADA Standards for Accessible Design (Standards), 28 C.F.R. pt. 36, App. A, or the Uniform Federal Accessibility Standards (UFAS), 41 C.F.R. § 101-19.6, App....
-
ADA Requirements
The regulations contain detailed architectural requirements called the ADA Standards for Accessible Design (Standards), 28 C.F.R. pt. 36, Appendix A....
-
E102.8 TIA (Section-by-Section Analysis)
This is the standard for TTY signals on the public switched telephone network interface (PSTN)....
-
Section 36.403 Alterations: Path of Travel (Section-by-Section Analysis)
These commenters also stated that they did not believe there was a statutory basis for "grandfathering'' facilities that comply with the 1991 Standards....
-
REFERENCES
Document Number FHWA-RD-00-067, Federal Highway Administration, McLean, VA. Transportation Research Board. 2005....
-
4. Assess During the Planning, Installation and Maintenance Phases
Each segment of the route should be assessed for compliance with the accessibility standards....
-
28 CFR Parts 35 and 36, Nondiscrimination on the Basis of Disability by State and Local Governments and Places of Public Accommodation; Equipment and Furniture (ANPRM)
Written comments must be postmarked and electronic comments must be submitted on or before [INSERT DATE 180 DAYS AFTER DATE OF PUBLICATION IN THE FEDERAL REGISTER]....
-
11B-607.4 Grab bars
[2010 ADA Standards] 607.4 Grab Bars. Grab bars for bathtubs shall comply with 609 and shall be provided in accordance with 607.4.1 or 607.4.2. Exceptions: 1. Reserved....
-
11B-405.5 Clear width
[2010 ADA Standards] 405.5 Clear Width. The clear width of a ramp run and, where handrails are provided, the clear width between handrails shall be 36 inches (915 mm) minimum....
-
11B-405.2 Slope
[2010 ADA Standards] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such...
-
§382.57(c)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
§27.71(k)(2) Clear floor or ground space.
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
§ 27.71(k)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
