Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
Search Results "Latch Side Clearance"
-
11B-604.8.1.1 Size
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters or Other Mobility Aids
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Sinks [4.24]
At those used briefly or intermittently, a side approach may be sufficient. A removable base cabinet can be used to make a sink adaptable for a forward approach....
-
3. FIXTURES and HARDWARE
Shelves: “If the clear floor space allows a parallel approach by a person in a wheelchair and the distance between the wheelchair and the shelf exceeds 10 inches, the maximum high side...
-
Features of Accessible Parking Spaces
Access aisles may be located on either side of the parking space except for angled van parking spaces which must have access aisles located on the passenger side of the parking spaces....
-
11B-406.5.3 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding any flared sides, or the blended transition leading to the landing....
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
11B-407.4.1 Car dimensions
TABLE 11B-407.4.1 ELEVATOR CAR DIMENSIONS MINIMUM DIMENSIONS DOOR LOCATION Door clear width Inside car, side...
-
1. Public Right-of-Way
Street ("Fillmore") and Steiner Street ("Steiner"); (2) Steiner between Grove Street ("Grove") and Fulton; and (3) the east side of 19th Street one block north of Wawona Street....
-
Handrail Requirements
Opposing comments referred to ergonomic studies which support a 2 ¼ inch clearance below the handrail. Response....
-
Doorways
In the final rule, clarification has been added that the 32 inch minimum clearance applies to those doors "providing user passage" into and within guest rooms not required to be accessible...
-
2.5.2.2 International Organization for Standardization (ISO) Standards
Risk management plays a critical and central role in the design of medical devices, and it also ties into IEC 60601-1 and FDA’s expectations for quality systems and premarket clearance or...
-
Toilet Compartments
The clear floor space required for a baby changing table by TAS 902.2 may overlap the water closet clearance based on TAS 604.3.2 since baby changing tables are considered convenience “fixtures...
-
Question 16
What is the optimal clearance needed under a bed to accommodate a mechanical lift?...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding 5 lb Weight - Forward Approach Power Chair
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding 5 lb Weight - Forward Approach Manual Wheelchair
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Error/Omission: When a transfer shower is used, it is often larger than the required 36" x 36" size.
Requirement: 4.21.2 Size and Clearances. Except as specified in 9.1.2, shower stall size and clear floor space shall comply with Fig. 35(a) or (b)....
-
212 and 606 Kitchens, Kitchenettes, Lavatories, and Sinks
The 1991 Standards, at section 4.24, and the 2010 Standards, at section 606, both require the clear floor space at sinks to be positioned for a forward approach and knee and toe clearance...
-
4.1.3 Adjustable Height Chairs with and without Footplates
Because these chairs with footplates are adjustable in height, when the chair height is fully lowered, a minimum 2” clearance is required from the floor to the bottom of the footplate as...
-
Architectural Builders Hardware 1811 Vertical Rod Protectors
Latch bolt cover 7" x 10" - 2 1/8" projection from door. 1811 - for pairs of doors. 1812 - right hand single unit. 1813 - left hand single unit....
-
Sargent 8800 Rim Exit Device
Features Designed for standard width stile applications on wood and metal doors Most functions are non-handed Single point rim latching device Single door...
-
DORMA C300 Series Locks Door Hardware
Product features Concealed fasteners on rose Door thickness range from 1-3/8"–1-3/4" 2-3/8" or 2-3/4" Backset 2-1/2" diameter rose 1/2" throw latch Non-handed for easy installation...
