requirements for accessible medical diagnostic equipment based on how the diagnostic equipment is used by the patients, including: diagnostic equipment used by patients in a supine prone, or side-lying...
Search Results "Hinge Side Clearance"
Commonly Searched Documents
-
C. Chapter 3: Technical Requirements (Section-by-Section Analysis)
-
R306.3 Roundabouts
Pedestrian street crossings at roundabouts can be difficult for pedestrians who are blind or have low vision to identify because the crossings are located off to the side of the pedestrian...
-
Areas of sport activity. (Section-by-Section Analysis)
In court sports, the accessible route would also have to directly connect both sides of the court. ...
-
406.7 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
1009.5.7 Grab Bars
Grab bars shall comply with 609 and be located on at least one side of the transfer system. The grab bar located at the transfer platform shall not obstruct transfer....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Other Safety tips:
Use the “Peep Hole” in the guestroom door to determine who is on the other side before you open the door. [All hotel staff members have uniforms and name tags....
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Floor Plan of Elevator Cars [4.10.9]
Hospital-type cars sized to accommodate stretchers (usually at least 80 inches long) can have side-opening doors if the car is at least 60 inches wide....
-
2.2.1 Demographic Information
Digital photographs of the user and device were taken from the front and side views to document the wheelchair accessories and configurations of WhMD user. Figure 2-1....
-
Pay Stations
Requirements for operable parts include: Clear floor space for a forward or side approach (§309.2) Location within accessible reach ranges (§309.3) One-hand operation...
- Pilot Rock AFT Series - End Accessible Traditional A-Frame Picnic Table - Using Recycled Plastic
- Pilot Rock AFT Series - End Accessible Traditional A-Frame Picnic Table - Using Lumber
- Kohler® Mazz Single-Handle Pull-Down Sprayer Kitchen Faucet in Vibrant Stainless
-
226 and 902 Dining Surfaces and Work Surfaces
Section 902.2 requires the provision of accessible knee and toe clearance....
-
Notes
The committee recognizes that future visionaries may be able to “re-vision” new devices to provide greater clearances and smaller base supports....
-
226.1 General
Consider work surfaces that are flexible and permit installation at variable heights and clearances....
-
Temporary Solutions for Election Day - Hallways and Corridors - Voters Who are Blind or Who Have Low Vision
Problem Two: Ceiling or wall-mounted television monitor has less than 80 inches of clearance between the floor and the bottom of the unit....
-
Mounting Height
It is also consistent with the minimum headroom clearance required for protruding objects....
-
Door and Gate Hardware [§404.2.7]
Recommendations: Specify hardware that is usable with a closed fist of loose grip Bars, pulls, and similar hardware should provide sufficient knuckle clearance (1½” minimum...
-
Privately Occupied Suite
The suite has a restroom and the way I see it, the clearance around the toilet, grab bars and plumbing fixtures are not code compliant. Three persons occupy the suite....
- Hager Companies Door Protection Plate 190S
- Innerface Trio Interior Signage