Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
Search Results "Transfer Surface Height"
-
11B-407.4.10.2 Surfaces
-
5a. Ramp Surface
Is the ramp surface at least 36 inches wide, excluding flared sides? [ADA Stds 4.7.3] Yes _____ No _____...
-
CONTENTS
Tables Available data do not support departing from the currently accepted standard of 19-Inch transfer surface height Adoption of a 19 inch height minimizes costs to health care...
-
407.8 Reach Height and Depth
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.8.2 or 407.8.3 according to its position established by the vertical reference plane specified...
-
4.34.6.4 WORK SURFACES
At least one 30 in (760 mm) section of counter shall provide a work surface that complies with the following requirements (see Fig. 50):...
-
M301.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the supine, prone, or side-lying position be usable with a patient lift and comply with either the...
-
5.7 Lift Compatibility
5.7 Lift Compatibility.
-
5.7 Lift Compatibility Recommendations
5.7 Lift Compatibility Recommendations
-
Platform Size and Surface
Platform Size and Surface To be part of an accessible route, lift platforms must provide the amount of clear space required for wheelchairs in ADAAG 4.2.4....
- American Standard Cadet 1.6 gpf Right Height Elongated Pressure Assisted Toilet
-
1136A.1 Receptacle heights
1136A.1 Receptacle heights. ...
-
407.12.3.2.1 Height (Section-by-Section Analysis)
407.12.3.2.1 Height (Section-by-Section Analysis) This section, presented in tabular form (Table 407.12.3.2.1), proposes alternative maximum heights for operable parts with obstructed...
-
Figure M5: Overview of M303 Diagnostic Equipment for Use by a Patient While Seated in a Wheelchair and 304 Diagnostic Equipment for Use by a Patient in a Standing Position (Mammography Machine Example)
Where the primary use of the equipment supports more than one patient position, it must comply with the requirements for each use. The mammography machine is usable by both people...
-
Sales and Service Elements and Spaces
[See subsections ...]
-
MEASUREMENT TECHNIQUE
MEASUREMENT TECHNIQUE The depth and width are measured along the centerlines of the seat, and the height from the floor to the highest point of the transfer surface: The depth...
- Bradley Grab Bars 1 1/2" with Exposed Mounting 817
-
John Brabyn, Ph.D., Director of Rehabilitation Engineering Research, Center on Low Vision and Blindness (NIDRR), Smith-Kettlewell Eye Research Institute
Handrails should contrast visually with background surfaces. Floor finishings should contrast with walls or a contrasting skirting should be provided....
- Pressalit Care PLUS Support Arm Height Adjustable Swing Grab Bar
-
Tactile Surface
The proposed rule included provisions that generally recognized alternative tactile surfaces equally detectable underfoot or other designs or technologies that provide equal or superior...
- Part 16- Save, Transfer & Restore a Backup Using Dropbox
-
Why are surface characteristics specified?
Why are surface characteristics specified? Over twenty-seven million Americans report some difficulty in walking....
-
H. Drop-off Area Height
Is the height of the covered passenger pickup/drop-off area at least 9'−6" to allow vans with raised roofs to use such area?...
-
6.3 Minority Reports
6.3 Minority Reports Because the Advisory Committee did not achieve consensus on the recommendation for a minimum transfer surface height standard, U.S....
-
Fishing Facilities
Word Fillable Form (0.8MB) Word Non-Fillable Form (0.8MB) PDF Non-Fillable Form (0.7MB)