Storage elements shall comply with at least one of the reach ranges specified in Section 11B-308.
Search Results "Transfer Surface Height"
-
11B-811.3 Height
-
11B-407.4.6.4.1 Height
Emergency control buttons shall have their centerlines 35 inches (889 mm) minimum above the finish floor.
-
11B-407.2.1.1 Height
Call buttons and keypads shall be located within one of the reach ranges specified in Section 11B-308, measured to the centerline of the highest operable part. Exception:...
- ADA Solutions, Inc. Cast in Place Tactile Surface Installation Video
- Gamco 1.25 Inch Diameter Straight Grab Bar with Snap Flange - 125S Series - Snap
- Gamco 1.5 Inch Diameter Straight Grab Bar with Concealed Flange - 150C Series-Concealed
- Gamco 1.5 Inch Diameter Straight Grab Bar with Snap Flange - 150S Series-Snap
-
5.7.1 Lift Compatibility Clearance in Base for Equipment Used by Patient in Supine, Prone, or Side-Lying Position
5.7.1 Lift Compatibility Clearance in Base for Equipment Used by Patient in Supine, Prone, or Side-Lying Position.
-
Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
Advancing Equal Access to Diagnostic Services: Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities The final report of the...
-
EZ-ACCESS The Gateway™ Solid Surface Portable Ramp Video
Requires the Registered User plan or above. Login!
-
Results comparison with current accessibility guidelines
First, it recommends a transfer height between 14 to 24” (35.6 to 61.0cm) and does not specify an allowable gap distance (2)....
- Ampetronic TalkPerfect Duplex Intercom, Speech Transfer System
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
5a. Ramp Surface
Is the ramp surface at least 36 inches wide, excluding flared sides? [ADA Stds 4.7.3] Yes _____ No _____...
-
CONTENTS
Tables Available data do not support departing from the currently accepted standard of 19-Inch transfer surface height Adoption of a 19 inch height minimizes costs to health care...
-
407.8 Reach Height and Depth
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.8.2 or 407.8.3 according to its position established by the vertical reference plane specified...
-
Re: Service Counters
The intent of this section of the code is to provide not only an accessible counter surface for the disabled to utilize, but also to allow a free flow interaction with an employee on the...
-
4.34.6.4 WORK SURFACES
At least one 30 in (760 mm) section of counter shall provide a work surface that complies with the following requirements (see Fig. 50):...
- American Standard Cadet 1.6 gpf Right Height Elongated Pressure Assisted Toilet
