Section 404.2.10 covers the current ADA Standards for door and gate surfaces on manual doors and gates.
Search Results "Hinge Side Clearance"
Commonly Searched Documents
-
Door and Gate Surfaces: ADA Standard Section 404.2.10
-
1010.2.13.1 Delayed egress locking system
An attempt to egress shall initiate an irreversible process that shall allow such egress in not more than 15 seconds when a physical effort to exit is applied to the egress side door hardware...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
- Magnetic Switch (BE9023)
- Magnuson Group RETTO Outdoor Waste Receptacle
- Gamco Horizontal Wall-Mounted Baby Changing Station Grey - BCS-2
- Gamco Horizontal Wall-Mounted Baby Changing Station Cream - BCS-1
- Landscape Forms Inc. Gretchen Bench
- AJW Architectural Products U2304 Unidoor C-fold/Multifold Towel Dispenser - Recessed
- AJW Architectural Products U2314 Unidoor C-fold/Multifold Towel Dispenser - Recessed
- AJW Architectural Products U2324 Unidoor C-fold/Multifold Towel Dispenser - Recessed
- Balco FMS-A and FMS-V Roll-Up Floor Mat
-
Floor Naming and Numbering
This is a little abstract one, but if you look at those elevator buttons, whether you’re in a building in San Francisco and you come in on the east side of the building and it’s Floor Level...
-
D) Curb Ramps at Intersections
This type of curb ramp has flared sides and must be used when pedestrians may enter or exit the curb ramp from the side....
-
2. Typical Issues for Individuals Who Are Blind or Have Low Vision
Typical Issues for Individuals Who Are Blind or Have Low Vision Objects that are wall mounted, that project into a pedestrian route from the side, or that are overhead can be hazards...
-
11B-403.5.1 Clear width
The clear width for aisles shall be 36 inches (914 mm) minimum if serving elements on only one side, and 44 inches (1118 mm) minimum if serving elements on both sides. 5. ...
-
IBC Comparison
Justice's Standards for Accessible Design* (column 2), which are based on the original ADA Accessibility Guidelines, and the International Building Code** (column 3) are reordered for side-by-side...
-
Part 2. Typical Issues for Voters Who Are Blind or Have Low Vision
Typical Issues for Voters Who Are Blind or Have Low Vision Objects that are wall-mounted, that project into a pedestrian route from the side, or that are overhead must be located so that...
- Panda TS.75 Aluminum Wood Clad Thermally Broken Folding Door System
-
11B-705.1.2.3 Islands or cut-through medians
pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches (51 mm) maximum on each side...
-
Overlapping Clear Floor Space
The Board has clarified that accessible lavatories are permitted to overlap clear floor space "opposite the shower compartment side where shower controls are positioned or where a seat is...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
M303.2.6 Edge Protection (Section-by-Section Analysis)
requires platforms with wheelchair spaces that are raised more than 1½ inches in height to provide a minimum 2-inch-high edge protection, measured from the surface of the platform, on each side...
-
Detailed Age Demographics
For phase 2 there is a small gap in the distribution around 25-35 years old causing the distribution on either side to be greater (Figure D2). Table D2....