Textured surfaces for tactile door warnings shall be standard within a building, facility, site, or complex of buildings....
Search Results "High Energy Door"
Filters
Commonly Searched Documents
-
4.29.7* STANDARDIZATION
-
Floor or Ground Surfaces: ADA Standard Section 304.2
Section 304.2 covers the current ADA Standards for the ground surfaces of a turning space.
-
11B-405.7 Landings
A level landing is needed at the accessible door to permit maneuvering and simultaneously door operation. FIGURE 11B-405.7 ‡‡ RAMP LANDINGS...
-
405.7 Landings
A level landing is needed at the accessible door to permit maneuvering and simultaneously door operation. Figure 405.7 Ramp Landings...
-
Adaptability
It is not intended to include moving walls, relocating plumbing, replacing fixtures, widening door frames, or other work more appropriately addressed in design and construction....
-
11B-703.8.1 General
High resolution variable message sign (VMS) characters shall comply with Sections 11B-703.5 and 11B-703.8.12 through 11B-703.8.14....
-
308.2.1 Unobstructed
Where a forward reach is unobstructed, the high forward reach shall be 48 inches (1220 mm) maximum and the low forward reach shall be 15 inches (380 mm) minimum above the finish floor or...
-
11B-308.1.2 Electrical receptacle outlets
branch circuits of 30 amperes or less and communication system receptacles shall comply with Section 11B-308 except the low reach shall be measured to the bottom of the outlet box and the high...
-
11B-308.1.2 Electrical receptacle outlets
branch circuits of 30 amperes or less and communication system receptacles shall comply with Section 11B-308 except the low reach shall be measured to the bottom of the outlet box and the high...
-
11B-703.8.1 General
High resolution variable message sign (VMS) characters shall comply with Sections 11B-703.5 and 11B-703.8.12 through 11B-703.8.14....
-
§ 38.71(b)(2)
(2) Vehicles designed for, and operated on, pedestrian malls, city streets, or other areas where level boarding is not practicable shall provide wayside or car-borne lifts, mini-high platforms...
-
11B-308.1.2 Electrical receptacle outlets
branch circuits of 30 amperes or less and communication system receptacles shall comply with Section 11B-308 except the low reach shall be measured to the bottom of the outlet box and the high...
-
11B-611.3 Operable parts
Operable parts, including doors, lint screens, and detergent and bleach compartments shall comply with Section 11B-309....
-
11B-409.4.7.3 Compartment
If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309 _|Operable Parts|_....
-
11B-409.4.7.3 Compartment
If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309 _|Operable Parts|_....
-
11B-611.3 Operable parts
Operable parts, including doors, lint screens, and detergent and bleach compartments shall comply with Section 11B-309....
-
Attachment C: HUMBOLDT COUNTY, CA
Grievance Procedure under The Americans with Disabilities Act
Within 15 calendar days after receipt of the appeal, the County Commissioner/ other appropriate high-level official or [his/her] designee will meet with the complainant to discuss the complaint...
-
602.6 Water Flow
The spout shall provide a flow of water 4 inches (100 mm) high minimum and shall be located 5 inches (125 mm) maximum from the front of the unit....
-
407.12.2.1 Unobstructed Side Reach (Section-by-Section Analysis)
Section-by-Section Analysis) This section proposes that, where the operable part is located 10 inches or less behind the vertical reference plane, the operable part must be 48 inches high...
-
Carr Corporation Specimen Pass-through Cabinet: SPT-12
It has two doors, one on each side. A door interlock system prevents both doors from opening at the same time....
-
§382.57(c)(7)(ii) Characters
Characters must be 3/16 inch (4.8 mm) high minimum based on the uppercase letter “I.” Characters must contrast with their background with a minimum luminosity contrast ratio of 3:1....
-
11B-308.2.1 Unobstructed
Where a forward reach is unobstructed, the high forward reach shall be 48 inches (1219 mm) maximum and the low forward reach shall be 15 inches (381 mm) minimum above the finish floor or...
-
§27.71(k)(7)(ii) Characters.
Characters must be 3/16 inch (4.8 mm) high minimum based on the uppercase letter “I.” Characters must contrast with their background with a minimum luminosity contrast ratio of 3:1....
-
§ 382.57(c)(7)(ii) Characters
Characters must be 3/16 inch (4.8 mm) high minimum based on the uppercase letter “I.” Characters must contrast with their background with a minimum luminosity contrast ratio of 3:1....
