Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
Search Results "Maximum Extent Practicable"
Filters
Commonly Searched Documents
-
11B-703.2.5 Character height
-
11B-1009.5.4 Transfer steps
Transfer step height shall be 8 inches (203 mm) maximum. The surface of the bottom tread shall extend to a water depth of 18 inches (457 mm) minimum below the stationary water level....
-
11B-1009.5.4 Transfer steps
Transfer step height shall be 8 inches (203 mm) maximum....
-
11B-505.5 Clearance
Handrails may be located in a recess if the recess is 3 inches (76 mm) maximum deep and 18 inches (457 mm) minimum clear above the top of the handrail....
-
M102.1 Defined Terms (Section-by-Section Analysis)
defined: health care provider, breast platform, patient support surface, transfer supports, positioning supports, prone position, supine position, examination tables, diagnostic purposes, maximum...
-
(C) NYCT’s interpretation of the ADA and DOT’s implementing regulations is too narrow.
facility,” for the reasons set forth above, DOT’s regulations (specifically, 49 CFR § 37.43(a)(1)) expressly require that the public entity shall make the alteration “in such a manner, to the maximum...
-
Site Selection
or parts of them (whether they comply with the older standards or were built before the passage of the ADA) are altered, then the altered areas must comply with the new standards to the maximum...
-
36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
The standards will allow independent entry to, use of, and exit from the equipment by individuals with disabilities to the maximum extent possible....
-
11B-232.1 General
alterations are originally planned), provided that each substitute cell— i) Is located within the same prison site; ii) Is integrated with other cells to the maximum...
-
DORMA ED700 Low-Energy Swing Door Operator
The ED700 may be used for door widths up to 48" (1220 mm) and a maximum weight of 200 lb (91 kg)....
-
2.3.3 Comparison of Dimensions with Standards and other Anthropometric Studies
• Maximum Forces for Hand-operated Controls: Compared to the maximum hand grip strength in a power grip, and lateral and thumb-forefinger pinch grips....
-
Shower Spray Unit
Comments also noted that delivered water should be "temperature limited" to the specified maximum (120 degrees) for consistency with American Society of Safety Engineers (ASSE) standards...
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
Height and Clearances [4.19.2]
Only a portion of the usable clear floor space can "count" as toe space, which is why a maximum depth and minimum height are specified for the front of the underlap of the required clear...
-
2.3.4 Analysis of Door Use Difficulty
The mean, median and range of WhMD user age, occupied width, occupied length and maximum power grip were also reported as we thought that these variables might help explain the door use...
-
4.26.3 STRUCTURAL STRENGTH
structural strength of grab bars, tub and shower seats, fasteners, and mounting devices shall meet the following specification: (1) Bending stress in a grab bar or seat induced by the maximum...
-
Section 5.0 Dissemination Activities
Completion of reports alone is not sufficient to ensure that the knowledge generated from research will be translated to practice....
-
Introduction
The Manual provides guidance on the practical application of legal requirements established in the statute and EEOC regulations....
-
BACKGROUND
monetary relief for aggrieved persons, civil penalties, and full compliance with title III provisions, such as requiring public accommodations to make reasonable modifications to policies, practices...
-
11B-1008.2.5.2 Elevated
The rise for any ramp run connecting elevated play components shall be 12 inches (305 mm) maximum....
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”. ...
