[36.104] (1) Any State or local government; (2) Any department, agency, special purpose district, or other instrumentality of a State or States or local government; and (3) The...
Search Results "Grade 1 Braille"
-
Public Entity
-
General: ADA Standard Section 409.1
Section 409.1 of the ADA Standards covers information in the current ADA Standards for private residence elevators.
-
11B-246.2 Camping facilities
two campsites and one additional campsite for each 100 campsites or fraction thereof, shall be accessed by and connected to sanitary facilities by travel routes with a maximum slope of 1:...
-
1009.3 Stairways
[DSA·AC & HCD 1-AC] In addition, exit stairways shall comply with Chapter 11A, Sections 1115A and 1123A, or Chapter 11B, Sections 11B-210 and 11B-504, as applicable....
-
3104.2 Separate structures
Exceptions: … [DSA-AC and HCD 1-AC] For purposes of accessibility in residential facilities as required by Chapters 11A and 11B, structurally connected buildings, buildings...
-
11B-809.8.1 Door Thresholds
Secondary exterior door thresholds, including sliding door tracks, shall be 3/4 inch (19.1 mm) high maximum with a 1:2 maximum slope....
-
11B-246.2 Camping facilities
two campsites and one additional campsite for each 100 campsites or fraction thereof, shall be accessed by and connected to sanitary facilities by travel routes with a maximum slope of 1:...
-
1009.3 Stairways
[DSA·AC & HCD 1-AC] In addition, exit stairways shall comply with Chapter 11A, Sections 1115A and 1123A, or Chapter 11B, Sections 11B-210 and 11B-504, as applicable....
-
R208 Detectable Warning Surfaces (Section-by-Section Analysis)
locations on pedestrian access routes and at transit stops: Curb ramps and blended transitions at pedestrian street crossings; Pedestrian refuge islands; Pedestrian at-grade...
-
R204 Pedestrian Access Routes (Section-by-Section Analysis)
Pedestrian access routes must be provided within: Sidewalks and other pedestrian circulation paths located in the public right-of-way; Pedestrian street crossings and at-grade...
-
4.9.4(3)
(3) The clear space between handrails and wall shall be 1‒1/2 in (38 mm)....
-
4.8.5(3)
(3) The clear space between the handrail and the wall shall be 1 - 1/2 in (38 mm)....
-
4.1.6(3)(a)(i)
(i) A slope between 1:10 and 1:12 is allowed for a maximum rise of 6 inches....
-
Mary Ann Hay, IALD, LEED™ AP. Artificial Lighting
This is a completely below-grade executive conference center....
-
§1630.14(d)(3) Incentives offered for employee wellness programs
the program (whether the program is a participatory program or a health-contingent program, or some combination of the two, as those terms are defined in regulations at 26 CFR 54.9802-1(...
-
§ 38.23(b)(7) Platform gaps
When the platform is at vehicle floor height with the inner barrier (if applicable) down or retracted, gaps between the forward lift platform edge and the vehicle floor shall not exceed 1/...
-
A. Exterior Routes
.: sidewalks and walkways), are there no steps, no abrupt level changes over 1/4", and no unramped curbs that will impede access for persons who use wheelchairs, walkers and other mobility...
-
14) Carpet and carpet tile
14) Carpet and carpet tile ADAAG: Same standards for carpet and carpet tile: maximum pile height of 1/2" (§4.5.3). UFAS: Carpet must have maximum pile height of 1/2"....
-
Performance Areas: ADA Standard Section 206.2.6
Section 206.2.6 covers scoping requirements in the most current ADA Standards for accessible routes in performance areas.
-
[2010 ADAS] 105.2.3 ASTM
per foot value for straight propulsion and for turning less than the average work per foot values for straight propulsion and for turning, respectively, on a hard, smooth surface with a grade...
-
WorkZone Safety Products Retractable Cone Bar
Light weight and extremely portable Easy to set up or remove Providing an instant inexpensive barrier to hazardous or controlled access areas Made with high quality industrial grade...
-
Hager Companies 4.75" Vestibule Actuator 2-659-0242
Vestibule Actuator Push to Open Text and ISA Logo Features: - Hard wired and wireless (hard wired standard) - Beveled edges - Graphics embossed onto the faceplate for durability - 304 grade...
-
610.3.1 Rectangular Seats
The rear edge of a rectangular seat shall be 2 1/2 inches (64 mm) maximum and the front edge 15 inches (380 mm) minimum and 16 inches (405 mm) maximum from the seat wall....
-
§ 38.125(c)(3) Ramp threshold
Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....
