Where elevated play components are provided, ground level play components shall be provided in accordance with Table 240.2.1.2 and shall comply with 1008.4....
Search Results "Adjustable Height Exam Table"
-
240.2.1.2 Additional Number and Types
-
407.4.1 Car Dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Table 407.4.1....
-
F. Chapter 5: Doorways, Circulation Paths, and Fare Collection Devices
., 2010 NPRM, Table T503.1 (Vertical Clearance at Doorways with Lifts or Ramps) and Table T803 (Areas Illuminated and Illuminance Levels) with 2016 Non-Rail Vehicle Guidelines, Sections...
-
Standards Applicable Under Section 504 as of March 15, 2012
Please refer to the following table of dates and accessibility standards for a quick reference to standards for complying with 34 CFR 104.23....
-
3.6.1. Hardware Replacement
Thus, the cost estimation employs weighted percentages in the respective rolling replacement schedules for captioning and audio description hardware, as shown in Table 3-24....
-
3.3.4. Audio Description Device Scoping Requirements
Table 3-18 shows the scoping requirements for audio description devices used in the cost estimation of the final rule. ...
-
4.2.2. High Accessibility Baseline
For further detail, the annual costs by cost category for the High Accessibility baseline are presented in Table 8-3 of Section 8.1 of the Appendices....
-
4.2.8. Zero Growth After Five Years
Table 4-22 shows the impact of altering the assumed growth rates. ...
-
11B-404.2.4.1 Swinging doors and gates
Swinging doors and gates shall have maneuvering clearances complying with Table 11B-404.2.4.1....
-
11B-240.2.1.2 Additional number and types
Where elevated play components are provided, ground level play components shall be provided in accordance with Table 11B-240.2.1.2 and shall comply with Section 11B-1008.4. ...
-
11B-240.2.1.2 Additional number and types
Where elevated play components are provided, ground level play components shall be provided in accordance with Table 11B-240.2.1.2 and shall comply with Section 11B-1008.4....
-
11B-404.2.4.1 Swinging doors and gates
Swinging doors and gates shall have maneuvering clearances complying with Table 11B-404.2.4.1....
-
3.2 Comparison of Sub-samples across Data Collection Sites
Table 3‒2: Gender, age and number of years with disability across sites. ...
-
R211 Signs (Section-by-Section Analysis)
In the 2004 ADA and ABA Accessibility Guidelines, characters on bus route signs must comply with the technical requirements for character height “to the maximum extent practicable."37 The...
-
II. ENFORCING THE ADA PART 2
Under the terms of the agreement with the Department, Exodus Women's Center agreed to: purchase an adjustable-height examination table for one office within two months of the agreement...
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
11B-502.8.2 Lettering
The additional sign shall clearly state in letters with a minimum height of 1 inch (25 mm) the following: "Unauthorized vehicles parked in designated accessible spaces not displaying...
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
4.10.12(3)
(3) Height. All floor buttons shall be no higher than 54 in (1370 mm) above the finish floor for side approach and 48 in (1220 mm) for front approach....
-
Scoping [4.1.3(20)]
Specifications in 4.34.2 and 4.34.3 were modified in June 1993 to allow either a forward or side approach and to provide further guidance on side reach heights....
-
A4.13.9 Door Hardware
To be effective, they should cover the door width, less approximately 2 in (51 mm), up to a height of 16 in (405 mm) from its bottom edge and be centered across the width of the door....
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
11B-502.8.2 Lettering
The additional sign shall clearly state in letters with a minimum height of 1 inch (25 mm) the following: "Unauthorized vehicles parked in designated accessible spaces not displaying...