Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....
Search Results "Sloped Area"
Commonly Searched Documents
-
§ 38.95(c)(3) Ramp threshold
-
11B-1009.5.2 Transfer space
A transfer space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
General Holding Cells and General Housing Cells: ADA Standard Section 232.2
Section 232.2 covers scoping requirements in the current ADA Standards for general holding cells and general housing cells.
-
1134A.6 Showers
Slope. The maximum slope of the shower floor shall be ½ inch (12.7 mm) per foot in any direction and shall slope to a drain....
-
Assistive Listening Systems: ADA Standard Section 216.10
Section 216.10 covers scoping requirements in the current ADA Standards for assistive listening signs.
-
11B-201.3 Temporary and permanent structures
Temporary buildings or facilities covered by these requirements include, but are not limited to, reviewing stands, temporary classrooms, bleacher areas, stages, platforms and daises, fixed...
- T&W Traffic Control Retractable Cone Bar
-
406 Curb Ramps
These include specifications for running slope, surface, clear width, and wet conditions. Consistent with the scope of the guidelines, these requirements apply to facilities on sites....
- SafePath: ADA Entry Level Landing Installation Training Video
-
M303.3.2 Beveled (Section-by-Section Analysis)
proposed that for equipment with a change in level at the entry to the wheelchair space, level changes greater than ¼ inch but not greater than ½ inch would be required to be beveled with a slope...
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
Addition
An expansion, extension, or increase in the gross floor area or height of a building or facility....
-
KITCHEN OR KITCHENETTE
[DSA-AC] A room, space or area with equipment for the preparation and cooking of food....
-
Summary of Significant Changes
Revised Requirements for Maximum Running Slope of Ramps: The 2016 Non-Rail Vehicle Guidelines revise and simplify the existing guidelines regarding running slope for ramps in non-rail vehicles...
-
Healthcare Stories - Alice Wong
Requires the Registered User plan or above. Login!
-
Visible Signals: ADA Standard Section 407.2.2.2
Section 407.2.2.2 covers the current ADA Standards for elevator visible signals.
-
11B-219.5 Permanent and portable systems
Permanently installed assistive-listening systems are required in areas if (1) they accommodate at least 50 persons or if they have audio-amplification systems, and (2) they have fixed seating...
-
3. New Construction vs. Alterations
curb ramps installed must meet the accessibility requirements of the ADA to the maximum extent feasible.10 Scoping requirements in the ADA Standards establish limitations for the running slope...
-
Wheelchair Spaces: ADA Standard Section 221.2
Section 221.2 covers scoping requirements in the current ADA Standards for wheelchair spaces.
-
Walk
An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts....
- Garaventa Evacu-Trac CD7 Evacuation Chair
-
11B-206.2.4 Spaces and elements
Accessible routes must connect all spaces and elements required to be accessible including, but not limited to, raised areas and speaker platforms. ◼ Exceptions: 1. Reserved....
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...