The surface of the transfer system shall not be sharp and shall have rounded edges....
Search Results "Shall"
Filters
Commonly Searched Documents
-
1009.5.5 Surface
-
4.34.6 KITCHENS
Accessible or adaptable kitchens and their components shall be on an accessible route and shall comply with the requirements of 4.34.6....
-
M304.3 Standing Supports
Standing supports shall be provided on each side of the standing surface and shall comply with M305.3....
-
1133A.1 General
Kitchens shall be on an accessible route and shall comply with this section. (See Figure 11A-10A.)...
-
§ 382.31 Refusal of transportation
In exercising this authority, carrier personnel shall not discriminate against any qualified individual with a disability on the basis of disability and their actions shall not be inconsistent...
-
606.2 Clear Floor Space
A clear floor space complying with 305, positioned for a forward approach, and knee and toe clearance complying with 306 shall be provided....
-
1117B.2.8
All telephones required to be accessible shall be equipped with a volume control....
-
606.2 Clear Floor Space
A parallel approach complying with 305 shall be permitted to lavatories and sinks used primarily by children 5 years and younger. 6....
-
606.2 Clear Floor Space
A parallel approach complying with 305 shall be permitted to lavatories and sinks used primarily by children 5 years and younger. 6....
-
11B-604.5 Grab bars
Grab bars for water closets shall comply with Section 11B-609. Grab bars shall be provided on the side wall closest to the water closet and on the rear wall....
-
Clearances: ADA Standard Section 1003.3
Clearances at boat slips and on boarding piers at boat launch ramps shall comply with 1003.3. Advisory 1003.3 Clearances....
-
Directional and Informational Signs: ADA Standard Section 216.3
Section 216.2 covers scoping requirements in the current ADA Standards for directional and informational signs.
-
11B-232.5.2 Partitions
Where solid partitions or security glazing separate visitors from detainees or inmates at least one of each type of cubicle or counter partition shall comply with Section 11B-904.6....
-
11B-502.7 Relationship to accessible routes
Parking spaces and access aisles shall be designed so that cars and vans, when parked, cannot obstruct the required clear width of adjacent accessible routes....
-
11B-225.2.1 Lockers
Where lockers are provided, at least 5 percent, but no fewer than one of each type, shall comply with Section 11B-811. Advisory 11B-225.2.1 Lockers....
-
WORK AREA EQUIPMENT
As used in this document, this term shall apply only to equipment that is permanently installed or built-in in employee work areas....
-
ELECTRIC VEHICLE CHARGING STATION (EVCS)
Where a multiport electric vehicle charger can simultaneously charge more than one vehicle, the number of electric vehicle charging stations shall be considered equivalent to the number...
-
11B-703.6 Pictograms
Pictograms shall comply with Section 11B-703.6. Advisory 11B-703.6 Pictograms....
-
11B-304.3.2 T-Shaped space
The turning space shall be a T-shaped space within a 60 inch (1524 mm) square minimum with arms and base 36 inches (914 mm) wide minimum....
-
604.2 Location
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
304.3.2 T-Shaped Space
The turning space shall be a T-shaped space within a 60 inch (1525 mm) square minimum with arms and base 36 inches (915 mm) wide minimum....
-
806.2.4 Toilet and Bathing Facilities
At least one bathroom that is provided as part of a guest room shall comply with 603....
-
1008.2.1 Ground Level and Elevated Play Components
Accessible routes serving ground level play components and elevated play components shall be permitted to use the exceptions in 1008.2.1. EXCEPTIONS: 1....
-
810.6.2 Routes and Destinations
Lists of stations, routes and destinations served by the station which are located on boarding areas, platforms, or mezzanines shall comply with 703.5....