(4) Bi-level lounge cars shall have doors on the lower level, on each side of the car from which passengers board, complying with §38.113, a restroom complying with §38.123, and at least...
Search Results "Latch Side Clearance"
Commonly Searched Documents
-
§ 38.111(a)(4)
- Just Manufacturing Classroom Concealed Ledgemount Teardrop Handles Restricted Swing Faucet
- Just Manufacturing Concealed Classroom Faucet with High Rise Spout
-
Handrail Requirements
Opposing comments referred to ergonomic studies which support a 2 ¼ inch clearance below the handrail. Response....
- Tobin Passage Levers Door Hardware
- Hager Companies Door Protection Plate 204S
- Halsey Taylor Bi-Level Barrier-Free Cooler
- Pilot Rock UT and UTH Series End Accessible Picnic Table Using Recycled Plastic
-
Elevator Car Controls
Specifically, the ANSI standard specifies a maximum reach height of 48 inches for forward or side reaches....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or other Mobility Devices
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
A4.4.1 GENERAL
The two principal cane techniques are the touch technique, where the cane arcs from side to side and touches points outside both shoulders; and the diagonal technique, where the cane is...
-
A4.4.1 General
The two principal cane techniques are the touch technique, where the cane arcs from side to side and touches points outside both shoulders; and the diagonal technique, where the cane is...
-
4.1.2(16)
Unless otherwise specified, accessible telephones may be either forward or side reach telephones. ** A bank consists of two or more adjacent public telephones, often installed as a unit...
-
1010.1.7 Thresholds
In occupancy Group R-2 or R-3, threshold heights for sliding and side-hinged exterior doors shall be permitted to be up to 7¾ inches (197 mm) in height if all of the following apply:...
-
2.2.5 Grip Strength
These measurements are important to the design of and/or standards development for some types of hand tools, hardware and electrical controls (e.g. scissors, some types of door latches,...
-
Paragraph (f) (Advisory Guidance)
Reduce the force needed to operate controls or latches and avoid the need for sustained pressure or activity (e.g., use guards rather than increased strength requirements to avoid accidental...
-
406.8 Detectable Warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
A7. Curb Ramps
Is the ramp surface at least 36” wide, excluding flared sides? [ADA Stds 4.7.3] Yes _____ No _____ b. Is the slope (up or down the ramp) no more than 1:12? ...
-
Can accessible spaces be parallel instead of perpendicular?
spaces be perpendicular instead of parallel, but perpendicular parking spaces are preferred at facilities located on sites because most allow users to park facing in or out depending on the side...
-
11B-406.6 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
11B-608.5.1 Reserved
In transfer type shower compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm...
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height....
-
Section 1.0 Background
The analysis was limited to WhMD dimensions, minimum clear floor areas, space requirements for maneuvering, knee and toe clearances, and reach limits....