Remember, when measuring the accessible route through the space, measure the aisle width as if the chairs are pulled out and occupied....
Search Results "Ramp Width"
-
Seating Locations
-
11B-608.2.2 Standard roll-in type shower compartments
shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full opening width...
-
Grab Bars
Grab bars must be perpendicular to the pool wall and extend the full width of the wall so a person can use them for support into the water....
-
1132A.5.1 General
Exception: A 39-inch (991 mm) length is acceptable at interior doors when a minimum clear opening width of 34 inches (864 mm) is provided....
-
11B-705.1.2.3 Islands or cut-through medians
Detectable warnings at pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches...
-
11B-608.2.2 Standard roll-in type shower compartments
shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full opening width...
-
1132A.5.1 General
Exception: A 39-inch (991 mm) length is acceptable at interior doors when a minimum clear opening width of 34 inches (864 mm) is provided....
- Tork Toilet Seat Cover Dispenser, 1/2 Fold
- Ascension Virtuoso Portable Wheelchair Lift Demonstration Video
- Detecto 6550 Portable Wheelchair Scale Operation
-
Passing Spaces [1017.4]
A trail tread width less than 60 inches does not permit two people using mobility devices to pass each other....
-
Amenities
Doors shall not swing into the clear floor space required by 903.2. 404 Doors, Doorways, and Gates. 404.2.3 Clear Width. Door openings shall provide a clear width of 32 inches minimum....
- Rebuilding Together Portland - Portland, OR
-
1) Where the Standard specifically refers to 303
Here it is clear that changes in level that comply with either the ¼" maximum vertical rise, the ½" maximum beveled rise with a slope not steeper than 1:2, or changes in level that are ramped...
-
Wheelchair Work Measurement Method
Work per meter values were also determined for the reference ramp grades and carpet/pad combinations....
-
§ 37.165(g)
(g) The entity shall permit individuals with disabilities who do not use wheelchairs, including standees, to use a vehicle's lift or ramp to enter the vehicle....
-
§ 38.125(a)(1) General
., lift, ramp or bridge plate) complying with either paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a seating location...
-
§ 38.125(a)(2) Exception
If level-entry boarding, portable or platform lifts, ramps or bridge plates meeting the applicable requirements of this section are provided on station platforms or other stops required...
-
§ 38.95(a)(2) Exception
If level-entry boarding, portable or platform lifts, ramps or bridge plates meeting the applicable requirements of this section are provided on station platforms or other stops required...
-
ASME
standard includes additional provisions for runway enclosures, electrical equipment and wiring, structural support, headroom clearance (which is 80 inches minimum), lower level access ramps...
- Tork Toilet Seat Cover Dispenser White
-
R302.2 Components
Curb ramps and blended transitions complying with R302.7 and R304; 5. Ramps complying with R407; 6....