Date of Construction or Alteration Applicable Standards Before September 15, 2010 1991 ADA Standards or Uniform Federal...
Search Results "ISO: International Organization for Standardization"
-
K. SIDEWALKS
-
§1191.1(a)
The guidelines serve as the basis for accessibility standards adopted by the Department of Justice and the Department of Transportation under the Americans with Disabilities Act....
-
K. SIDEWALKS
Date of Construction or Alteration Applicable Standards Before September 15, 2010 1991 ADA Standards or Uniform Federal Accessibility Standards (“UFAS”)...
-
Introduction
This regulation contains enforceable standards based on ADAAG and addresses certain provisions in the standards (e.g., elevator exception, alterations to primacy function areas). ...
-
233 Residential Facilities
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different Additional Requirements...
-
[2010 ADAS] 105.2.3 ASTM
ASTM F 1292-99 Standard Specification for Impact Attenuation of Surface Systems Under and Around Playground Equipment (see 1008.2.6.2)....
-
11B-233.3.6 Graduate student and faculty housing at a place of education
Access Board's Note to Reader: The Department of Justice’s ADA standards also require the following: Social service center establishments. ...
-
224 Transient Lodging Guest Rooms
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different Additional Requirements...
-
11B-233.3.6 Graduate student and faculty housing at a place of education
Access Board's Note to Reader: The Department of Justice’s ADA standards also require the following: Social service center establishments. ...
-
11B-233.3.6 Graduate student and faculty housing at a place of education
Access Board's Note to Reader: The Department of Justice’s ADA standards also require the following: Social service center establishments. ...
-
2.0 Methodology
In many cases, variables underlying the U.S. standards are not included in other standards. Thus, in our comparisons, we simply omitted values for those variables....
-
C. Toilet Rooms:
See the 2010 Standards §§ 216.8, 703.5 and 703.7.2.1....
-
A. Final Regulatory Assessment (EO 13563 and EO 12866)
equipment will be required to comply with the Standards’ technical requirements....
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
An analysis under the 2010 Standards starts with the requirement that all spaces must be accessible unless specifically exempted. 2010 Standards, § 201.1. ...
-
Section 36.406(d) Social Service Center Establishments
The NPRM explained the Department’s belief that transferring coverage of social service center establishments from the transient lodging standards to the residential facilities standards...
-
Section 36.406(d) Social Service Center Establishments (Section-by-Section Analysis)
The NPRM explained the Department's belief that transferring coverage of social service center establishments from the transient lodging standards to the residential facilities standards...
-
Section 36.406(e) Housing at a Place of Education (Section-by-Section Analysis)
standards....
- Caroma® USA Sydney Smart II Round Front Toilet
-
R105.3 Undefined Terms
The meaning of terms not specifically defined in R105.5, the referenced standards, or regulations issued by Federal agencies that adopt this document as accessibility standards shall be...
-
Airport Kiosk Accessibility
The design specifications we proposed were based largely on Section 707 of the 2010 ADA Standards for Accessible Design....
-
Section 35.151(b) Alterations
describe standards for path of travel during alterations to a primary function....
-
Section 35.151(b) Alterations (Section-by-Section Analysis)
describe standards for path of travel during alterations to a primary function....
-
5. Exception from the Requirements of M302 for Weight Scales with Integral Seats
Four commenters responded: three concurred (an accessibility consultant, disability rights organization, and a state agency concerned with accessibility); and one commenter (a manufacturer...
-
Section 4.26.4
• Section 4.26.4 of the 1991 Standards requires handrail gripping surfaces to have edges with a minimum radius of 1/8 inch....