The surface of the clear ground space must be firm and stable. Additional information on firm and stable surfaces is provided in the trails section of this guide....
Search Results "Trail Surface"
Commonly Searched Documents
-
Surface, Slope, and Openings [1011.2.2, 1011.2.3, and 1011.2.4]
-
Surfaces: ADA Standard Section 505.8
Section 505.8 covers the current ADA Standards for handrail gripping surfaces and also any adjacent surfaces to them.
-
Step 1: Determine the Applicability of FSTAG
After a decision has been made to design or alter a trail, three questions must be asked: 1. Does the work meet the definitions for new construction or alteration?...
-
Carpet: ADA Standard Section 302.2
Section 302.2 covers the current ADA Standards for carpet.
-
Surface and Slope [1012.4 and 1012.5]
The surface of parking spaces and pull-up spaces for RVs must be firm and stable....
-
11B-302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge. Carpet edge trim shall comply with Section 11B-303....
-
Step 4: Calculate Cumulative Deviation Percentage
The drawing shows that: Deviations occur on more than 15 percent of the trail because 15 percent of 950 feet equals 142.5 feet (15 percent of 290 meters equals 43.5 meters), but...
-
Dining Surface and Work Surface
Commenters expressed concern about use of the terms "dining surfaces" and "work surfaces" and urged the Board to include definitions of the terms in the final rule....
-
F247.5 Outdoor Constructed Features
This section requires at least 20 percent, but not less than one, of each type of outdoor constructed feature provided at each location on trails, other than within facilities provided on...
-
Must accessible surfaces be paved?
Concrete, asphalt, and other paved surfaces are more reliably compliant, but other materials, such as wood, and construction methods can be used to provide firm and stable surfaces. ...
-
Exterior Surfaces
However, some natural surfaces, such as compacted earth, soil treated with consolidants, or materials stabilized and retained by permanent or temporary geotextiles (mesh), gridforms, or...
- AccessRec PathMat Temporary ADA Beach Access Mat
-
F247.4 Trail Facilities
Where provided on trails, facilities shall comply with F247.4. Advisory F247.4 Trail Facilities. ...
-
11B-1008.2.6 Ground surfaces
Ground surfaces on accessible routes, clear floor or ground spaces, and turning spaces shall comply with Section 11B-1008.2.6. Advisory 11B-1008.2.6 Ground surfaces....
-
7.4.5.1 Size
The passing space shall be either: A space 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum; or The intersection of two trails providing a T-shaped space complying...
-
11B-302.1 General
A firm surface resists deformation by either indentations or particles moving on its surface....
-
General: ADA Standard Section 302.1
Section 302.1 of the ADA Standards covers information in the current ADA Standards for floor or ground surfaces.
-
F201.4.1 Documentation and Notification When Exceptions Used for Trails and Beach Access Routes
Federal agencies shall document the basis for not fully complying with a specific provision in 1017 or 1018 on a portion of a trail or beach access route based on Exception 1 in 1017.1 or...
- Nate’s 1st Training Run
-
Floor and Ground Surfaces
This guide explains requirements in the ADA Standards for floor and ground surfaces. ...
-
T302.4 Surface Discontinuities
Surface discontinuities shall be ½ inch (13 mm) high maximum and shall be beveled with a slope not steeper than 1:2. EXCEPTIONS: 1....
-
1015.5 Surface
This section requires the surface of the clear ground space and turning space to be firm and stable....
-
1017.9 Protruding Objects
This section requires constructed elements on trails, resting intervals, and passing spaces to comply with the technical requirements for protruding objects in 307 of the Architectural Barriers...
-
Check Writing Surfaces: ADA Standard Section 904.3.3
Where provided, check writing surfaces shall comply with 902.3....