The resting interval length shall be 60 inches (1525 mm) long minimum.
Search Results "Trail Surface"
Filters
Commonly Searched Documents
-
1017.8.1 Length
-
General: ADA Standard Section 302.1
Section 302.1 of the ADA Standards covers information in the current ADA Standards for floor or ground surfaces.
-
7.4.6 Tread Obstacles
Tread obstacles on trails shall not exceed 2 inches (50 mm) in height measured vertically to the highest point. ...
-
Nate’s 1st Training Run
Nate Johnson trains for the trails in a GRIT Freedom Chair!...
-
Floor and Ground Surfaces
This guide explains requirements in the ADA Standards for floor and ground surfaces. ...
-
T302.4 Surface Discontinuities
Surface discontinuities shall be ½ inch (13 mm) high maximum and shall be beveled with a slope not steeper than 1:2. EXCEPTIONS: 1....
-
1015.5 Surface
This section requires the surface of the clear ground space and turning space to be firm and stable....
-
Check Writing Surfaces: ADA Standard Section 904.3.3
Where provided, check writing surfaces shall comply with 902.3....
-
11B-505.8 Surfaces
Handrail gripping surfaces and any surfaces adjacent to them shall be free of sharp or abrasive elements and shall have rounded edges....
-
Constructed Features
Constructed Features are commonly found along trails or as part of trails....
-
Wetland Trail Design and Construction
Most experienced trail crews try to avoid wetlands because of the construction and maintenance problems they pose....
-
Access Trax: Accessible Beach and Outdoor Event Mats
Access Trax® is the only modular, foldable, ADA-compliant portable pathway empowering people of all abilities to safely and easily access outdoor terrains such as sand, grass,...
-
Better Recreation Surfaces
Better recreation surfaces for playgrounds and trails. Best playground surface. Best trail surface. Nature playgrounds. Nature trails....
-
Documenting Exceptions and Notifying the U.S. Access Board About Exemptions
the reason that full compliance wasn't achieved and file it with the project records for the trail construction or alteration project....
-
Surface [1018.3]
The surface of beach access routes and resting intervals must be firm and stable. Sand is not a firm and stable surface....
-
3.2.3 Surface
The ground surface in all camp living areas shall be firm and stable. The type of surface should be appropriate to the setting and level of development....
-
11B-306.3.4 Clearance reduction
Exception: The knee clearance shall not be reduced at built-in dining and work surfaces required to be accessible by Section 11B-226.1....
-
Clear Tread Width [1017.3]
The clear tread width of trails must be a minimum of 36 inches (figure 2)....
-
F201.4.1 Documentation and Notification When Exceptions Used for Trails and Beach Access Routes
Federal agencies shall document the basis for not fully complying with a specific provision in 1017 or 1018 on a portion of a trail or beach access route based on Exception 1 in 1017 or...
-
4.7.4 Surface
Surfaces of curb ramps shall comply with 4.5....
-
4.7.4 SURFACE
Surfaces of curb ramps shall comply with 4.5....
-
1017.7.1 Maximum Running Slope and Segment Length
Not more than 30 percent of the total length of a trail shall have a running slope steeper than 1:12 (8.33%)....
-
1017.7.1 Maximum Running Slope and Segment Length
Not more than 30 percent of the total length of a trail shall have a running slope steeper than 1:12 (8.33%)....
-
11B-1008.2.6.1 Accessibility
Ground surfaces shall comply with ASTM F 1951. Ground surfaces shall be inspected and maintained regularly and frequently to ensure continued compliance with ASTM F 1951....
