In the rare cases where an entire trail or beach access route is exempted, Federal agencies must notify the Access Board about the exemption. Sample notification forms are in the...
Search Results "UNCRPD (United Nations Convention on the Rights of Persons with Disabilities)"
Commonly Searched Documents
-
Notifying the Access Board When an Entire Trail or Beach Access Route is Exempted [F204.4.1]
-
1133A.2.1, Item 2
2. U-shaped kitchens, designed with a cooktop or sink located at the base of the U, which provides a knee and toe space in accordance with Section 1133A.7 to allow for a forward...
-
1132A.3, Item 6
6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
-
1133A.7, Item 2
2. The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance.
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following:
-
1132A.3, Item 6
6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
-
1133A.7, Item 2
2. The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance.
-
1133A.2.1, Item 2
2. U-shaped kitchens, designed with a cooktop or sink located at the base of the U, which provides a knee and toe space in accordance with Section 1133A.7 to allow for a forward...
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following: The knee and toe space shall be clear and unobstructed, or removable...
-
11B-809.10.8.6 Controls
Faucet controls and operating mechanisms shall comply with Section 11B-309.4.
-
11B-809.10.6.4 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Continuous reinforcement shall be installed in the walls of showers 30 inches (762 mm) maximum to 38 inches (965 mm)...
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor. Where towel bars are provided they shall be...
-
E101.3 Conventional Industry Tolerances (Section-by-Section Analysis)
E101.3 Conventional Industry Tolerances (Section-by-Section Analysis) This section would provide that dimensions are subject to conventional industry tolerances except where dimensions...
-
§ 36.311(b)
(b)
-
§ 36.311(b)(2) Assessment factors
(2) Assessment factors. In determining whether a particular other power-driven mobility device can be allowed in a specific facility as a reasonable modification under paragraph...
-
V. RESERVATION OF RIGHTS
reasonably foreseeable that Olympia’s planned Events Center or relocation shall fail to meet the schedule set forth in paragraph 13: (i) Olympia shall immediately provide written notice to the United...
-
Requirement 3. Usable doors.
on an accessible route shall be designed in such a manner that all the doors designed to allow passage into and within all premises are sufficiently wide to allow passage by handicapped persons...
-
11B-809.8 Doors
Primary entry doors, required exit doors, secondary exterior doors and interior doors intended for user passage shall comply with this section and Section 11B-404.2. Doors to small...
-
4. Coverage of Real-Time Text
RTT is important as an equivalent alternative to voice communications for persons who are deaf, or who have limited hearing or speech impairments....
-
CASI Accessibility Construction Inspection Checklist
CASI ACCESSIBILITY CONSTRUCTION INSPECTION CHECKLIST The CASI Professional Practice Standards Committee in collaboration with the California Commission on Disability Access (CCDA)...
-
CALBO Accessibility Construction Inspection Checklist
CALBO ACCESSIBILITY CONSTRUCTION INSPECTION CHECKLIST The CALBO Access Committee in collaboration with the California Commission on Disability Access (CCDA) checklist committee is...
-
29 CFR Part 1630, Regulations to Implement the Equal Employment Provisions of the ADA (Title I Regulations with amendments issued through May 2016)
29 CFR Part 1630, Regulations to Implement the Equal Employment Provisions of the ADA Authority: 42 U.S.C. 12116 and 12205a of the Americans with Disabilities Act, as amended....
- #CrappyCurb
- What It's Like to Navigate Chicago in a Wheelchair - Rolling On, Episode 1
