Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance....
Search Results "Seat Width"
Filters
Commonly Searched Documents
-
404.2.4 Maneuvering Clearances
-
Transfer Steps
Each transfer step must have a tread depth of 14 inches minimum to 17 inches maximum and a minimum tread width of 24 inches....
-
Technical Requirements [1018 and 1018.1, Exception 3]
The technical requirements for beach access routes include specific provisions for connections, the surface, clear width, obstacles, openings, running slope, cross slope, resting intervals...
-
Transfer Surface Size – M301.2.2 Supine, Prone, or Side-Lying Position
Transfer Surface Size – M301.2.2 Supine, Prone, or Side-Lying Position The issues were discussed and decided in the full committee meeting as follows: depth of 17 inches minimum and width...
-
7.4.11.1 Clear Space
The clear space shall not overlap the trail width but may overlap a resting space or passing space. The slope of the clear space shall not exceed 1:20 (5 percent) in any direction....
-
4.34.6.5(7)
The knee space shall have a clear width of 30 in (760 mm) and a clear depth of 19 in (485 mm)....
-
2.6 Passing Spaces
ORARs with a clear width less than 60 inches (1525 mm) shall provide passing spaces complying with 2.6 at intervals of 200 feet (61 m) maximum....
-
Turning Space: ADA Standard Section 809.2.2
EXCEPTION: Turning space shall not be required in exterior spaces 30 inches (760 mm) maximum in depth or width. Advisory 809.2.2 Turning Space....
-
4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
A pedestrian access route shall be provided for the full width of a shared use path. 5.2.1 Width and Clearance The minimum paved width for a two-directional shared use...
-
§ 37.167(j)(1)(ii)
(ii) Individuals sitting in or a fold-down or other movable seat in a wheelchair securement location....
-
Benches
Benches in amphitheaters must comply with the requirements in ABAAS section F221 for assembly areas, including wheelchair spaces, companion seats, designated aisle seats, and lawn seating...
-
1008.4.2 Clear Floor or Ground Space
When designing play components with manipulative or interactive features, consider appropriate reach ranges for children seated in wheelchairs....
-
1008.4.2 Clear Floor or Ground Space
When designing play components with manipulative or interactive features, consider appropriate reach ranges for children seated in wheelchairs....
-
1008.4.2 Clear Floor or Ground Space
When designing play components with manipulative or interactive features, consider appropriate reach ranges for children seated in wheelchairs....
-
11B-1008.4.2 Clear floor or ground space
When designing play components with manipulative or interactive features, consider appropriate reach ranges for children seated in wheelchairs....
-
11B-1008.4.2 Clear floor or ground space
When designing play components with manipulative or interactive features, consider appropriate reach ranges for children seated in wheelchairs....
-
Clarification on Standard Roll-In Shower Compliance
shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full opening width...
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...
-
505.10 Handrail Extensions
In assembly areas, extensions shall not be required for ramp handrails in aisles serving seating where the handrails are discontinuous to provide access to seating and to permit crossovers...
-
Size and Clearances [4.21.2]
The 36 by 36 inch dimension, measured to the interior finish, keeps front and side grab bars within reach from the seat....
-
§382.81(b)
(b) You must provide an adjoining seat for a person assisting a passenger with a disability in the following circumstances:...
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
11B-903.7 Wet locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....