They’re going to look at the knee and toe clearances that our guidelines establish in order to determine whether or not the table is generally useable to individuals who use wheelchairs....
Search Results "Latch Side Clearance"
Filters
Commonly Searched Documents
-
Rulemaking Authority
-
Minimum Clear Opening
Representatives Edwards, Frank, and Fish expressed their support for the Option One specification on minimum clearance which is consistent with the ANSI Standard....
-
11B-604.5.2 Rear wall
The rear wall grab bar shall be 36 inches (914 mm) long minimum and extend from the centerline of the water closet 12 inches (305 mm) minimum on one side and 24 inches (610 mm) minimum on...
-
Cassette Recordings (Advisory Guidance)
The cost of a duplicator can be higher depending upon the number of copies produced on a single run, and whether the duplicator can produce standard speed two-sided copies or half-speed...
-
1127B.5, Item 4
landing 4 feet (1219 mm) deep shall be provided at the upper end of each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or flared sides...
-
Hall Lanterns [4.10.4]
Up and down lantern indicators can be placed one above the other or side-by-side....
-
3.1.4.1 Width of Non-RV Campsite Vehicle Parking Areas
Where a double camping unit is provided and two parking areas are provided to accommodate two vehicles side-by-side in an accessible parking spur, the total width of the vehicle parking...
-
1009.7.2 Separation
The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
-
A4.6.3 Parking Spaces
The increasing use of vans with side-mounted lifts or ramps by persons with disabilities has necessitated some revisions in specifications for parking spaces and adjacent access aisles....
-
At least one percent of all fixed seats in all seating areas must be aisle seats with no armrest, or with a removable or folding armrest
to wheelchair seating locations, at least one percent of all fixed seats in all seating areas must be aisle seats with no armrest, or with a removable or folding armrest, on the aisle side...
-
A1
Is a relatively level (1:50 or 2% maximum slope in all directions) access aisle provided adjacent and parallel to the side of the vehicle pull-up area?...
-
11B-607.5 Controls
Controls shall be between the bathtub rim and grab bar, and between the open side of the bathtub and the centerline of the width of the bathtub....
-
Clear Floor or Ground Space [4.31.2], Mounting Height [4.31.3]
Clear Floor or Ground Space [4.31.2], Mounting Height [4.31.3] Generally, access can be provided with either a forward or side approach....
-
5.1.6 Clear Floor or Ground Space
One full unobstructed side of the clear ground space shall adjoin or overlap the trail or ORAR, as applicable, or another clear ground space....
-
Protruding Objects
One element of a barrier-free meeting space for participants who are blind or have low vision requires cane-detectable protruding objects and sufficient head clearance....
-
Adaptability
Rooms need to be designed to provide required clear floor space at fixtures, turning space, and door clearance....
-
Counters and Bars [5.2]
Types of Counters Maximum Height Minimum Length Knee Clearance (forward approach) Dining/Bars (service) 34 in 60 in required Dining/Bars...
-
M101.3 Equivalent Facilitation
However, the standards include technical criteria for clearance in or around the base of the equipment for lift compatibility to allow the use of a patient lift by patients with disabilities...
-
Auditorium accessible seating
So if you have a wheelchair occupying the end floor space, one row of seats has only one way out and the other forward row may not even have the required 12” minimum clearance in front of...
-
11B-404.2.9 Door and gate opening force
These forces do not apply to the force required to retract latch bolts or disengage other devices that hold the door or gate in a closed position....
-
11B-404.2.9 Door and gate opening force
These forces do not apply to the force required to retract latch bolts or disengage other devices that hold the door or gate in a closed position....
-
11B-404.2.9 Door and gate opening force
These forces do not apply to the force required to retract latch bolts or disengage other devices that hold the door or gate in a closed position....
-
Kuriki 2-in-One Paper Holder
Unlike traditional designs where the surface sits above the holder, this side-by-side layout creates a more modern and practical look....
-
5.1.6 Clear Floor or Ground Space
One full unobstructed side of the clear ground space shall adjoin or overlap the trail or ORAR, as applicable, or another clear ground space. ...
