in 5 feet and 6 feet high (add 4" for base) Each compartment includes a 5" deep shelf and a double prong ceiling hook Available as 1 wide or 3 wide units 1 wide units come fully assembled...
Search Results "Designated Aisle Seat (Assembly)"
Commonly Searched Documents
- Salsbury Industries Designer Wood Locker Triple Tier 3 Wide
- Salsbury Industries Designer Wood Locker Four Tier 1 Wide
- Salsbury Industries Designer Wood Locker Double Tier 3 Wide
- Salsbury Industries Designer Wood Locker Triple Tier - 1 Wide
-
407.4.7 Designations and Indicators of Car Controls
407.4.7 Designations and Indicators of Car Controls. Designations and indicators of car controls shall comply with 407.4.7....
-
CHAPTER 16A STRUCTURAL DESIGN
CHAPTER 16A STRUCTURAL DESIGN ETA Editor's Note This Pocket Guide contains only the excerpts from California Building Code Chapter 16A that are adopted by Division of the State...
-
CHAPTER 16 STRUCTURAL DESIGN
CHAPTER 16 STRUCTURAL DESIGN ETA Editor's Note This Pocket Guide contains only the excerpts from California Building Code Chapter 16 that are adopted by Division of the State...
-
CHAPTER 16A STRUCTURAL DESIGN
CHAPTER 16A STRUCTURAL DESIGN ETA Editor's Note This Pocket Guide contains only the excerpts from California Building Code Chapter 16A that are adopted by Division of the State...
- Moen Commercial – Behind the Design of M-Power Products
-
Attachment G: Modifications to Newly Constructed Facilities
Attachment G: Modifications to Newly Constructed Facilities
-
§382.81(a)
(a) For a passenger who uses an aisle chair to access the aircraft and who cannot readily transfer over a fixed aisle armrest, you must provide a seat in a row with a movable aisle armrest...
- Salsbury Industries Designer Wood Locker Double Tier 1 Wide
-
3.2 Getting on the Table
An accessible table allows for a more thorough exam, as compared to an exam where you remain seated in your wheelchair or on a chair....
- Salsbury Industries Designer Wood Locker Single Tier 3 Wide
- Salsbury Industries Designer Wood Locker Single Tier 1 Wide
-
Conflict with Historic Preservation Design Codes
Two commenters expressed concern about a possible conflict between the Act's accessibility requirements and local historic preservation codes (including compatible design requirements)....
-
Does a wheelchair user have to use the seat belt and shoulder harness?
Transit operators may establish a policy that requires the seat belt and shoulder harness to be used by all riders, including those who use wheelchairs as well as those who use vehicle seats...
-
Same Management or Building
The 2010 Standards add a new exception that allows multiple assembly areas that are in the same building and under the same management, such as theaters in a multiplex cinema and lecture...
- DOT/FTA Americans with Disabilities Act (ADA): Guidance Circular FTA C 4710.1
-
M305.2.5 Surface Hazards
Transfer supports and surfaces adjacent to transfer supports shall be free of sharp or abrasive components and shall have eased edges.
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2.
-
M305.2 Transfer Supports (Section-by-Section Analysis)
This is an introductory section. As discussed above in Section IV.E.1. (Significant Changes – Transfer Supports), the Access Board strengthened the transfer support requirements and...
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
The proposed rule did not provide any specific restrictions regarding surface hazards around the transfer supports. No public comments were submitted on this issue, but the MDE...
-
5.4 Transfer Supports
5.4 Transfer Supports.