*(Optional finger grip in lieu of lock) Hinges: Full length, heavy duty, stainless steel hinge. Collars: #22 ga stainless steel finished and sized to match cabinet....
Search Results "Swing Clear Hinge"
Commonly Searched Documents
- AJW Architectural Products U581 Series U581 1.5 Gallon Sanitary Napkin Disposal - Recessed
-
Minimum Rear Wall Required.
Using the 2010 ADA Standards for Accessible Design, the minimum bench length would be 42" and the width of the clear floor space adjacent to the end of the bench would be 30"....
-
Display Screens
suggested that we change the requirement for display screens such that they must not only be visible, but also readable, from a point located 40 inches (1015 mm) above the center of the clear...
-
Section 1630.2(j)(1)(i) Broad Construction; not a Demanding Standard
As Congress noted in the legislative history of the ADAAA, “[t]o be clear, the purposes section conveys our intent to clarify not only that ‘substantially limits’ should be measured by a...
-
General Regulatory Approach
We must structure our response to this mandate in a way that allows for clear and consistent implementation by the carriers, and clear and consistent enforcement by the Department....
-
Diagonal Curb Ramps
These curb ramps must have a 48 inch minimum clear space at the bottom....
-
M303.3.3 Ramped (Section-by-Section Analysis)
in level at the entry of a wheelchair space, level changes greater than ½ inch high would be required to be ramped and comply with technical requirements for running slope, cross slope, clear...
-
R210.3 Shared Use Paths
require objects along or overhanging any portion of a pedestrian circulation path to comply with the proposed technical provisions for protruding objects in R402 and to not reduce the clear...
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
This knee and toe space would also have to be clear of obstructions....
-
Section 35.171 Acceptance of complaints. (Section-by-Section Analysis)
(Section-by-Section Analysis) In the NPRM, the Department proposed changing the current language in § 35.171(a)(2)(i) regarding misdirected complaints to make it clear that if an agency...
- Pilot Rock T-600 Series Caterpillar Picnic Table
- AJW Architectural Products U719 96"W x 48"H J-Mold Mirror - Four Sided Frame - Plate Glass
- Lutron Sivoia QS Wireless Shading System
- Spectrum Aquatics Glacier Platform Pool Lift
- Symmons Temptrol II (BP Series) Shower System BP-56-500-B30-V
- Inpro Corporation SignScape® Regulatory Signs
- BEA Inc. LPR36 Series 36" Low Profile Push Plate
-
1130A.1 General
The accessible route shall pass through the primary entry door, and shall connect with all additional exterior doors, required clear floor spaces at kitchen appliances and bathroom fixtures...
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
11B-406.6 Islands
The clear width of the accessible route at islands shall be 60 inches (1524 mm) wide minimum. Where curb ramps are provided, they shall comply with Section 11B-406....
-
1016.6 Openings
Where possible, drainage grates should be located outside the minimum clear width of the outdoor recreation access route....
-
20. Does topping off a play surface trigger its replacement with an accessible surface?
surface along accessible routes located within the boundary of the play area, including the entry and exit points of the ground level play components required to be accessible, as well as at clear...
-
5.8.2.7 Base Support Allowance
Base support is permitted to obstruct the clear floor space if it fits within the allowed base support volume. Base supports can be a maximum of 1½ inches high....