FEATURES: It is speed adjustable using the enclosed adjustment tool and designed to never leak hydraulic fluid Extremely safe and does not offer resistance if closed quickly in an...
Search Results "Adjustable Height Counter"
Commonly Searched Documents
- D&D Technologies SureClose 57 Hydraulic Closer and Hinge
-
2.4.2 Considerations of Manufacturers in Accessible MDE Design
This has significant implications for adjustable height table design as many designs lose mechanical advantages as they go lower....
- Magnuson Group WH Hanger Style Wall Rack
- Pilot Rock M-32/17 Campfire Ring
- ASI Storage Solutions Plastic Cubby Shelf
-
11B-106.5 Defined terms
. ◼ ACCESS AISLE ACCESSIBILITY ACCESSIBLE ACCESSIBLE ELEMENT ACCESSIBLE MEANS OF EGRESS ACCESSIBLE ROUTE ACCESSIBLE SPACE ADAPTABLE ADDITION ADJUSTED CONSTRUCTION...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
percent of the adjusted construction cost of alterations, structural repairs or additions....
- Sargent 1331 Series Aluminum Door Closer
- Cal-Royal 300 Series Hydraulic Door Closers
- Sennheiser SK 2020-D-US Rugged Transmitter
- Mariak Industries Motorized Window Coverings
- American Dryer, Inc eXtremeAir eXt Hand Dryer
-
Section G: Ramps
(§405.3) G3 Is the rise (height) for any ramp run 30" or less?...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
When toilet and bathing facilities have doorway openings instead of doors, such as at airports or stadiums, the geometric identification symbol should be located at the proper height adjacent...
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
1115B.8.4
Toilet tissue dispensers shall be located on the wall within 12 inches (305 mm) of the front edge of the toilet seat, mounted below the grab bar, at a minimum height of 19 inches (485 mm...
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
QUESTION: WHAT CONSTITUTES AN ALTERATION TO A PLATFORM FOR PURPOSES OF TRIGGERING THE APPLICATION OF SECTION 37.42 REQUIREMENTS?
For example, if the platform height relative to the top of rail is raised, if the old surface is removed and/or a new surface put down, or if there is a reconstruction of or structural change...
-
E. Chapter 4: Boarding and Alighting
the technical requirements for the slope of ramps in non-rail vehicles by specifying a single standard (1:6) for maximum running slope applicable to ramps deployed to roadways or curb-height...
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
4.1.3(17)(a)
At least one public telephone per floor shall meet the requirements for a forward reach telephone3. 1 Additional public telephones may be installed at any height....
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
2.2 Key Measurement Variables and Procedures
Reaches and lifts: One-handed maximum reaches recorded at 5 different heights in three different directions for up to four different weight conditions (maximum of 60 reaches total). 4...