The controls shall be interlocked with the vehicle brakes, propulsion system, or door, or shall provide other appropriate mechanisms or systems, to ensure that the vehicle cannot be moved...
Search Results "Control End Wall"
Commonly Searched Documents
-
§ 38.83(b)(2)(i) Requirements
-
§ 38.159(b)(2)(i) Requirements
The controls shall be interlocked with the vehicle brakes, transmission, or door, or shall provide other appropriate mechanisms or systems, to ensure that the vehicle cannot be moved when...
- Symmetry Vertical Platform Lift VPC-EL
-
§35.131(a) (Section-by-Section Analysis)
The Act and the regulation distinguish between illegal use of drugs and the legal use of substances, whether or not those substances are "controlled substances," as defined in the Controlled...
-
12112(c)(2)(C)(III)
(III) the centralized control of labor relations; and...
-
12112(c)(2)(C)(iii)
(iii) the centralized control of labor relations; and...
-
SECTION 412 AIRCRAFT-RELATED OCCUPANCIES
412.2 Airport traffic control towers. …...
-
505.10.2 Top Extension at Stairs
Extensions shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent stair flight....
-
7(2)(a)
(a) Bathrooms that have reinforced walls for grab bars (see Requirement 6) would meet section 100.205(c)(3)(iv) if: Note: Cabinets under lavatories are acceptable provided the bathroom...
-
Extensions
Handrails that are not continuous must have horizontal extensions at both the top and bottom of the ramp at least 12 inches long that are rounded or returned smoothly to walls, posts, or...
- Georgia-Pacific enMotion® Brushed Stainless Automated Touchless Soap Dispenser
-
11B-404.2.4.3 Recessed doors and gates
A door can be recessed due to wall thickness or because of the placement of casework and other fixed elements adjacent to the doorway....
-
Shower Spray Unit
In the proposed rule, the Board included a requirement that shower spray units have a water on/off control for greater access....
- Landscape Forms Inc. FGP Bench Collection
-
Do access aisle borders (in blue) have to be painted on all four sides to be considered compliant?
I would also say that both of the "end" lines would/could be within the required length. ...
-
1007.8.1 System requirements
Two-way communication systems shall provide communication between each required location and a central control point location approved by the fire department....
-
TABLE 601 FIRE-RESISTANCE RATING REQUIREMENTS FOR BUILDING ELEMENTS (hours)
HT Ad B Structural framea Including columns, girders, trusses 3b 2b 1 0 1 0 HT 1 0 Bearing walls...
- Pilot Rock WXT and WXTH Picnic Table Using Aluminum
- Pilot Rock WUT and WUTH Picnic Table - Using Aluminum
-
903.3.1.1.1 Exempt locations
Generator and transformer rooms separated from the remainder of the building by walls and floor/ceiling or roof/ceiling assemblies having a fire-resistance rating of not less than 2 hours...
-
Accessible Pathway & Corridor: Minimum Clear Floor Space Required for 360-degree Turn
These data are based on measurements of wheeled mobility users performing 360-degree turns within an enclosed square space built with mock walls....
-
Infrared Systems
Emitters must be installed high up on the walls and more emitters may be added and located as necessary to insure proper signal strength....
-
804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....