When play components are located on an accessible route, the height required to transfer directly to the entry point or seat of a play component has a minimum of 11 inches (280 mm) and a maximum...
Search Results "Maximum Dimension"
Commonly Searched Documents
-
Entry Points and Seats
-
1003.2.12.2 Opening limitations
Exception: The triangular opening formed by the riser, tread and bottom rail at the open side of a stairway shall be of a maximum size such that a sphere of 6 inches (152mm) in diameter...
-
SEAT HEIGHT MEASUREMENT DETAIL
Measuring to the top of the bolster would account for the maximum transfer height differential from a wheeled mobility device....
-
T502.4 Doorways with Steps on Over-the-Road Buses
Hinges and other door mechanisms shall be permitted to protrude 4 inches (100 mm) maximum into the door opening clear width at or below 48 inches (1220 mm) in height measured from the lowest...
-
3. EXCLUSIONS
Nevertheless, since the intended use of such excluded facilities may change with time or in emergencies, compliance with these DoD Standards is recommended to the maximum extent that is...
-
2.1.2.3 New York State Standards
Given a 1000 Hz signal at a level equal to the long-time average level of speech, the average value of the magnetic field should be 100 mA/meter +/- 3 dB between 100 to 8000 Hz, with a maximum...
-
11B-703.7.2.6.3 Unisex toilet and bathing facilities
The vertices of the triangle shall be located ¼ inch (6.4 mm) maximum from the edge of the circle....
- GE® 30" Drop-In Electric Range JDS28DFWW
- Bradley Diplomat Foam Soap Dispenser 6A01-11
-
UDI
All dimensions were taken to the extremes of the equipment including any object attached to the device like a ventilator....
-
11B-604.5.1 Side wall
The side wall grab bar shall be 42 inches (1067 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1372 mm) minimum from the rear wall with...
- Panda S.81 All Aluminum Multi-Slide Door System
-
Accessible Boat Slips
Edge protection is not required, but if provided, it can be 4 inches high maximum and 2 inches deep maximum at the continuous clear openings....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
R211 Signs (Section-by-Section Analysis)
In the 2004 ADA and ABA Accessibility Guidelines, characters on bus route signs must comply with the technical requirements for character height “to the maximum extent practicable."37 The...
-
Measures and Procedures
The space for the legs and feet has a fixed dimension of 14.5” deep by 22.5” wide (36.8x57.2cm)....
-
Utilities at Recreation Sites
Place elongated openings more than a quarter of an inch wide with the long dimension perpendicular to the primary direction of travel....
- American Standard Times Square Deck- Mount Bathtub Faucet with Personal Shower
- Elkay Cane Apron LKAPREZL for use with EZ Bi-Level Drinking Fountains
-
1008.2.4.1 Ground Level
The clear width of accessible routes shall be permitted to be 36 inches (915 mm) minimum for a distance of 60 inches (1525 mm) maximum provided that multiple reduced width segments are separated...
-
1009.3.3 Handrails
The clear width between required handrails shall be 33 inches (840 mm) minimum and 38 inches (965 mm) maximum. EXCEPTIONS: 1....
-
702.1 General
have permanently installed audible and visible alarms complying with NFPA 72 (1999 or 2002 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1), except that the maximum...
-
11B-405.9 Edge protection
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (12.7 mm) maximum within 10 inches (254 mm) horizontally of the minimum landing area...