Allow 5" (125mm) minimum clearance from bottom of dispenser to top of any horizontal projection for filling dispenser from below unit....
Search Results "Hinge Side Clearance"
-
Bobrick MatrixSeries Seat-Cover Dispenser B-5221
-
1134A.7 Water closets
Water closets shall be located within bathrooms in a manner that permits a grab bar to be installed on at least one side of the fixture....
-
Bobrick Recessed Sharp Disposal B-35016
Door equipped with full-length stainless steel piano-hinge at bottom; swings down for easy replacement of sharps container....
-
Bobrick Surface-Mounted Sharp Disposal B-350169
Door equipped with full-length stainless steel piano-hinge at bottom; swings down for easy replacement of sharps container....
-
EZ-ACCESS Suitcase Singlefold AS Ramp
After taking out two hinge pins, users are able to easily separate the portable single-fold ramp into two lightweight sections with ergonomic handles. ...
-
A) Accessible Parking
Van-Accessible Parking Spaces One of every eight accessible parking spaces, but always at least one, must be accessible for vans with a side-mounted lift....
-
Thresholds at Doorways
The 1991 Standards and the 2010 Standards require raised thresholds that exceed ¼ inch in height to be beveled on each side with a slope not steeper than 1:2....
-
410.6 Doors and Gates
Side doors and gates shall provide a clear width 42 inches (1065 mm) minimum....
-
Openings, Width and Length of Wheelchair Space
Wheelchair access can be provided onto the ride vehicle in many ways, including, but not limited to, rear entry, side entry, or side entry with a turntable....
-
Rotational Penetrometer
The test for stability requires the caster of the Rotational Penetrometer to be moved from side to side to determine the horizontal displacement of the surface material....
-
1. Accessible toilet
Accessible toilet with rear and side grab bars, clear floor space for wheelchair transfer, and an accessible flush valve....
-
5.2.3 Transfer Surface Measurement
The transfer surface should be measured from the center-point of each side of the transfer surface....
-
A7
Is the width of the curb ramp surface at least 36 inches (not counting the side flares)? [ADA Standards § 4.7.3] Yes No...
-
B7-a
Is the curb ramp surface at least 36 inches wide, excluding flared sides? [ADA Standards § 4.7.3] Yes No...
-
§ 38.73(a)(1)
(1) All passenger doorways on vehicle sides shall have minimum clear openings of 32 inches when open....
-
§ 38.53(a)(1)
(1) Passenger doorways on vehicle sides shall have clear openings at least 32 inches wide when open....
-
408.4.6 Car Controls
Control panels shall be centered on a side wall....
-
206.2.12 Court Sports
In court sports, at least one accessible route shall directly connect both sides of the court....
-
Expert Report of Douglas J. Anderson, RAS, CASP, LCM Architects (August 8, 2018)
Voting Area: There is insufficient maneuvering clearance in front of voting station (1991 ADA Stds 4.2.3; 2010 ADA Stds 304.3)....
-
Executive Summary
Key requirements apply to clear floor area, knee and toe clearances, maneuvering clearances, reach limits, grip force requirements and door usability factors....
-
Service Counters
Does that mean the full depth of the counter, from customer side to employee side? Can a split level counter be used (lower customer side, raised employee side)? ...
-
Swan Barrier-Free Folding Shower Seat BF-2300
Key Benefits Two seat styles will fit back wall or either side wall. The BF-2300L is for left side wall installation. The BF-2300R is for right side wall installation....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
1.17 Unobstructed view
purposes of this Consent Order, shall mean and refer to a view to the screen that is not blocked or interfered with by any seats, railings, or other objects and is configured to have visual clearance...
