Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
Search Results "Horizontal Standing Support"
Commonly Searched Documents
-
11B-307.4.1 Guy braces
-
"Doing work'' or "performing tasks.'' (Section-by-Section Analysis)
The Department agrees with this statement but cautions that unless the animal is individually trained to do something that qualifies as work or a task, the animal is a pet or support animal...
-
Doing "work'' or "performing tasks.'' (Section-by-Section Analysis)
The Department agrees with this statement but cautions that unless the animal is individually trained to do something that qualifies as work or a task, the animal is a pet or support animal...
-
M301.3 Supports (Section-by-Section Analysis)
An editorial change was made to this section as a result of the change in M301.3.2, described below, to replace the word “stirrups” with the term “leg supports.”...
-
M301.3.3 Head and Back Support (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed to place the requirements for head and back support for diagnostic equipment used by patients in the supine, prone, or side-lying position in M301...
-
M305.5 Head and Back Support (Section-by-Section Analysis)
(Section-by-Section Analysis – M302.3.3), the technical requirements for head and back supports from M301 and M302 have been relocated to M305 Supports....
-
5.4.4.1 Transfer Support Distance from Transfer Surface for Stretchers
5.4.4.1 Transfer Support Distance from Transfer Surface for Stretchers....
-
M304.1 General (Section-by-Section Analysis)
This is an introductory section.
-
5.4.4.1 Transfer Support Distance from Transfer Surface Recommendation for Stretchers
5.4.4.1 Transfer Support Distance from Transfer Surface Recommendation for Stretchers The Committee recommends locating the transfer support along the long side of the of the transfer...
-
Sec.36.308(a)(1)(ii)(A)
(A) Are dispersed throughout the seating area;
-
1009.4 Elevators
In order to be considered part of an accessible means of egress, an elevator shall comply with Sections 1009.4.1 and 1009.4.2.
- EZ Dock EZ Launch® System for Kayaks and Canoes
-
F103 Modifications and Waivers
The Architectural Barriers Act authorizes the Administrator of the General Services Administration, the Secretary of the Department of Housing and Urban Development, the Secretary of...
-
5.4 Transfer Supports
5.4 Transfer Supports....
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2....
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2....
-
M301.3.1 Transfer Supports
A.1) A transfer support will extend horizontally along the side of the patient scanning/imaging table at least the minimum width of the transfer surface, but in all cases a 28 inches minimum...
-
Tips for Assisting People Who Have Disabilities that are Not Apparent
Service and Emotional Support Animals Be aware that people who have disabilities that are not apparent may travel with emotional support animals or other service animals....
-
Locker Rooms
Locker Rooms Recommendations: Benches of the required size (24 inches deep and at least 48 inches long) can be integrated with lockers so that back support is provided from a wall....
-
1009.2 Continuity and components
Horizontal exits complying with Section 1026. Ramps complying with Section 1012, and Chapter 11A, Sections 1114A and 1122A, or Chapter 11B, 11B-405, as applicable....
-
M304.1 General
Diagnostic equipment used by patients in a standing position shall comply with M304....
-
1003.2.13.2 Enclosed stairways
handrails and shall either incorporate an area of refuge within an enlarged floor-level landing or shall be accessed from either an area of refuge complying with Section 1003.2.13.5 or a horizontal...
-
General: ADA Standard Section 226.1
Section 226.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dining surfaces and work surfaces.