The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
Search Results "Hinge Side Clearance"
-
11B-406.5.12 Detectable warnings
-
11B-705.1.2.3 Islands or cut-through medians
pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches (51 mm) maximum on each side...
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
1. Location
Curb ramps must be placed to enable a person with a mobility disability to travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...
-
H1
[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
-
7b.
[ADA Stds 4.13.9] Yes _____ No _____ A clear floor space on the latch side of the door (pull side) allows a person using a wheelchair or scooter to pull the door open and then...
-
4.30.6 Mounting Location and Height
Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
10.3.1(5)
Signs shall be placed at frequent intervals and shall be clearly visible from within the vehicle on both sides when not obstructed by another train....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
406.4 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing....
-
R306.2 Pedestrian Signal Phase Timing
All pedestrian signal phase timing shall comply with section 4E.06 of the MUTCD (incorporated by reference, see R104.2) and shall be based on a pedestrian clearance time that is calculated...
-
Bobrick ClassicSeries Surface Mounted Seat-Cover Dispenser B-221
Allow 5" (125mm) minimum clearance from bottom of dispenser to top of any horizontal projection for filling dispenser from below unit....
-
M303.3.3.5 Handrails
Ramps with a rise greater than 6 inches (150 mm) shall provide handrails on both sides....
-
§ 1194.22(e)
(e) Redundant text links shall be provided for each active region of a server-side image map....
-
T602.3 Approach
One full unobstructed side of each wheelchair space shall adjoin or overlap a passenger access route....
-
d-ii
Are handrails installed on both sides of each ramp segment? [ADA Standards § 4.8.5] Yes No...
-
f-ii
Are handrails installed on both sides of each ramp segment? [ADA Standards § 4.8.5] Yes No...
-
Sec.36.308(a)(1)(i)
(i) Provide a reasonable number of wheelchair seating spaces and seats with removable aisle-side arm rests; and...
-
M303.3.3.5 Handrails
Ramps with a rise greater than 6 inches (150 mm) shall provide handrails on each side....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located on the side wall of the compartment adjacent to the 16 inches (406 mm) minimum...
-
11B-307.4.1 Guy braces
FIGURE 11B-307.4.1 GUY BRACES FIGURE 11B-307.4 VERTICAL CLEARANCE...
