The landing clear length shall be 60 inches (1524 mm) long minimum....
Search Results "Clear Width at Turn"
-
11B-405.7.3 Length
-
11B-405.7.3 Length
The landing clear length shall be 60 inches (1524 mm) long minimum....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised (load) position....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised (load) position....
-
Escalators
Escalators must have a clear width of 32 inches minimum (810.9)....
-
11B-406.6 Islands
The clear width of the accessible route at islands shall be 60 inches (1524 mm) wide minimum. Where curb ramps are provided, they shall comply with Section 11B-406....
-
Executive Summary
For example, a user can set parameters for width of occupied device and identify the extent of participants accommodated....
-
11B-206.2.19 Pedestrian street crossings
The curb ramp (excluding any flared sides) or blended transition shall be contained wholly within the width of the pedestrian street crossing served....
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Pole-supported pedestrian traffic-control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
-
11B-206.2.19 Pedestrian street crossings
The curb ramp (excluding any flared sides) or blended transition shall be contained wholly within the width of the pedestrian street crossing served....
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Pole-supported pedestrian traffic-control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
-
11B-705.1.2.5 Blended transitions
California Building Code (CBC) Regulations for Accessibility in the Triennial Code Cycle: "Requirements for detectable warning surfaces at blended transitions have been clarified in terms of “width...
-
1.4.4. Operational Requirements
of a digital movie produced or distributed with such features through the provision of open movie captions, the Department has added a requirement that movie theater staff know how to turn...
-
5.2.3 Transfer Surface Measurement Recommendation for M301 and M302
5.2.3 Transfer Surface Measurement Recommendation for M301 and M302 Description: The transfer surface size standard has two components: width and depth....
-
Conclusions
Our findings support those dimensions but also suggest that the width could be reduced to 28 in. Our analysis based on static anthropometry measurements....
-
Stanley Access Technologies Dura-Care 7200 Manual Sliding Door
SPECIFICATIONS CONFIGURATIONS: 2- or 4-Panel, 2-Panel S&D, Trackless TYPICAL HEIGHT: 88" | OPTION: Taller Available TYPICAL WIDTH: 2-Panel | OPTION: 84" TO 108"; Clear Door...
-
Guest Rooms with Communication Features: ADA Standard Section 806.3
If a telephone-like handset is used, the external speakers can be turned off when the handset is removed from the cradle....
-
4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
A pedestrian access route shall be provided for the full width of a shared use path. 5.2.1 Width and Clearance The minimum paved width for a two-directional shared use...
-
R306 Pedestrian Street Crossings (Section-by-Section Analysis)
Crossings (Section-by-Section Analysis) The technical requirements in R306 address pedestrian signal phase timing and pedestrian street crossings at roundabouts and multi-lane channelized turn...
-
Toilet Room Configuration
The 450 angle facilitated maneuvering by eliminating the need for sharp turns in small spaces....
-
Location: ADA Standard Section 409.3.2
Section 409.3.2 covers the current ADA Standards for the location of private residence elevator doors.
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
