These include specifications for running slope, surface, clear width, and wet conditions. Consistent with the scope of the guidelines, these requirements apply to facilities on sites....
Search Results "Clear Width at Turn"
-
406 Curb Ramps
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
809 Residential Dwelling Units
809 Residential Dwelling Units 809 Residential Dwelling Units 809.1 General 809.1 General 809.2 Accessible Routes 809.2.1 Location 809.2.2 Turning...
-
§ 36.303(g)(9)(iii)
(iii) Turn on open movie captions if the movie theater is relying on open movie captioning to meet the requirements of paragraph (g)(3) of this section; and...
-
§ 36.303(g)(9)(iii)
(iii) Turn on open movie captions if the movie theater is relying on open movie captioning to meet the requirements of paragraph (g)(3) of this section; and...
- Canine Assistants
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
- LaCantina Contemporary Clad Slider System
- LaCantina Multi-slide Thermally Controlled Aluminum Sliding Door System
-
B. Slopes
[ADA Stds. 4.8.4] Yes __ No __ N/A __ Comments: ___________________________________________ ...for corridors into which at least one door swings, is there at least 54" clear floor...
-
RECOMMENDATIONS
The latter includes studies to determine optimum design specifications, such as: toilet height and location, grab bar height, positioning, and location; clear floor space; and size of fixtures...
-
Transfer Surface Size – M302.2.2 Seated Position
The Subcommittee discussed the width and agreed on a 21 inch minimum width based on anthropometric data and industry human factors experience....
-
References
Changes in level greater than ½ inch (13 mm) high shall be ramped, and shall comply with 405 or 406. 304.2 (Turning Space) Floor or Ground Surfaces....
-
4.1 Wheeled Mobility Device Dimensions
Data on occupied device sizes is most valuable for establishing clear floor area requirements....
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
R305.2.2 Parallel Curb Ramps
On parallel curb ramps, detectable warning surfaces shall be placed on the turning space at the flush transition between the street and sidewalk....
-
R304.5.4 Counter Slope
The counter slope of the gutter or street at the foot of curb ramp runs, blended transitions, and turning spaces shall be 5 percent maximum....
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Lateral most point, left (arm, leg, WhMD or accessory) Used to measure Occupied Width....
- LaCantina Aluminum Wood Slider System
- LaCantina Multi-slide Aluminum Wood Sliding Door System