Strenuous objections were raised by some business commenters to the proposed provisions of the guidelines concerning check-out aisles, counters, and scoping for hotels and nursing facilities...
Search Results "Character Height (Raised)"
Commonly Searched Documents
-
Comments on specific provisions of proposed ADAAG (Preamble, Section-by-Section Analysis)
-
M307.2 Tactilely Discernible (Section-by-Section Analysis)
The most common method to ensure that buttons and similar controls are tactilely discernible is to raise part or all of the control surface above the surrounding surface and at a distance...
-
M101.5 Dimensions (Section-by-Section Analysis)
One commenter and the MDE Advisory Committee raised concerns about providing standards for obese patients and pediatric patients....
-
(a) Single-story dwelling units
Sunken or raised functional areas, such as a sunken living room, are also exempt from access specifications, provided that such areas do not interrupt the accessible route through the remainder...
-
Employee for ADA Compliance
The designated employee(s) or consultant shall be knowledgeable about or receive training on the ADA, shall serve as the primary contact(s) on disability-related issues and concerns raised...
-
Employee for ADA Compliance
The designated employee(s) or consultant shall be knowledgeable about or receive training on the ADA, shall serve as the primary contact(s) on disability-related issues and concerns raised...
-
4.10.14* EMERGENCY COMMUNICATIONS
It shall be identified by a raised or recessed symbol and lettering complying with 4.30 and located adjacent to the device....
-
§ 37.47(e)
., installations of elevators, raising the entire passenger platform, or alterations of similar magnitude and cost)....
-
1134A.6, Item 4
The grab bar reinforcement shall be a minimum of 6 inches (152.4 mm) nominal in height. Â Â Â Â ...
-
1132A.4.1 Thresholds
Changes in height at interior door thresholds (e.g., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm). Thresholds shall comply with the following:...
-
1134A.6, Item 4
The grab bar reinforcement shall be a minimum of 6 inches (152.4 mm) nominal in height....
-
§ 38.153(c)(1)
(1) Doors shall have a minimum clear width when open of 30 inches (760 mm), measured from the lowest step to a height of at least 48 inches (1220 mm), from which point they may taper to...
-
11B-809.10.6.4 Reinforcement for grab bars
The grab bar reinforcement shall be 8 inches (203 mm) minimum in height....
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
Jean Tessmer
I have used this tool for concrete, asphalt, and raised board walk construction work on federal and private commercial projects....
- ADA Sign Depot California Title 24 Unisex Restroom Door Sign Circle and Triangle - 12" x 12"
-
11B-207.1 General
The directional signs must comply with the requirements of Section 11B-703.5 for visual characters. ◼...
- Cybex Total Access Seated Leg Curl Exercise Machine
- Cybex Total Access Overhead Press Exercise Machine
- Viking Electronics AES-2000 Entry System
-
1132A.4.1 Thresholds
Changes in height at interior door thresholds (e.g., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm). Thresholds shall comply with the following:...
-
Accessible Courtroom Stations
Other applicable specifications include accessible work surface heights and toe and knee clearance....
-
607 Bathtubs
Changes made to this section include: revision of grab bar mounting heights (607.4) integration of provisions for grab bars specific to residential dwelling units that were...
-
4.31.2 CLEAR FLOOR OR GROUND SPACE
Figure 44 Mounting Heights and Clearances for Telephones...