Are signs mounted on both sides of the elevator hoist way door opening (for each elevator and at each floor) that designate the floor with 2-inch minimum-height raised letters and Braille...
Search Results "Clear Opening"
Commonly Searched Documents
-
e-vi
-
607.5 Controls
Controls shall be between the bathtub rim and grab bar, and between the open side of the bathtub and the centerline of the width of the bathtub....
-
AUTOMATIC DOOR
A door equipped with a power-operated mechanism and controls that open and close the door automatically upon receipt of a momentary actuating signal....
-
§100.10(a)(2)
(2) Prohibit a private club, not in fact open to the public, which, incident to its primary purpose or purposes, provides lodgings which it owns or operates for other than a commercial purpose...
-
4.1.7(2)(b)
EXCEPTION: If it is determined that no entrance used by the public can comply with 4.14, then access at any entrance not used by the general public but open (unlocked) with directional signs...
-
Certain Sports/ Recreation and Other Structures (§203.10 - §203.14)
solely for refereeing, judging, or scoring a sport raised boxing/ wrestling rings water slides and raised diving boards/ platforms animal containment areas not open...
-
Can van spaces required for a parking garage be located in a surface lot instead?
Open lots do not provide the same level of protection, security, and lighting as garage parking....
-
Captioning
However, various technologies have been developed to provide open or closed captioning for movie theaters....
-
11B-705.2 Detectable directional texture
The width of the directional texture shall be equal to the width of the transit vehicle’s door opening. The depth of the texture shall not be less than 36 inches (914 mm)....
-
Getting From Here to There—Outdoor Recreation Access Routes
Design outdoor recreation access routes to meet technical requirements for running and cross slopes, resting intervals, surface, clear tread width, passing spaces, tread obstacles, protruding...
- Wikk Industries Inc. Bollard With Push Plate PART # BPFSMPREP36PCCL
-
Profile
It wasn't clear this was an object that actually had four wheels....
-
Bedside Clearance [9.2.2(1)]
Clear floor space is required at accessible controls and elements (e.g., thermostats), storage facilities (e.g., closets), and should be provided at non-fixed furnishings (e.g., dressers...
-
§ 38.95(d) Mobility aid seating location
Spaces for persons who wish to remain in their wheelchairs or mobility aids shall have a minimum clear floor space 48 inches by 30 inches....
-
Benches
Do not allow this clear space to overlap the outdoor recreation access route, trail, or beach access route, so that using the bench or clear space doesn't limit travel past the bench and...
-
Staff Training
Staff Training Ongoing staff training is essential to ensure that accessible equipment (particularly pool lifts) and pool facilities are available whenever a pool is open....
-
11B-804.6.2 Operable parts
Bottom-hinged appliance doors, when in the open position, shall not be required to comply with Section 11B-309.3....
-
711.4.6 Floor fire doors
Floor fire doors used to protect openings in fire-resistance-rated floors shall be tested in the horizontal position in accordance with ASTM E 119, and shall achieve a fire-resistance rating...
-
Head Room [4.4.2]
This is important at open stairways and along sloped walls....
-
Doors
Recommendation: Compliance with 4.13.6 is recommended because while wider door openings may facilitate access, they do not fully compensate for latch-side clearance, particularly on the...
-
11B-608.9 Shower floor or ground surface
Where drains are provided, grate openings shall be ¼ inch (6.4 mm) maximum and flush with the floor surface....
-
§ 38.173(c)
(c) In stations where open platforms are not protected by platform screens, a suitable device or system shall be provided to prevent, deter or warn individuals from stepping off the platform...
-
11B-804.6.2 Operable parts
Bottom-hinged appliance doors, when in the open position, shall not be required to comply with Section 11B-309.3....