Standard English uses contractions like "don't" as a short way of writing two words, such as "do" and "not." In Braille there are many additional contractions....
Search Results "Check Writing Surface"
Filters
Commonly Searched Documents
-
11B-703.3 Braille
-
11B-703.3 Braille
Standard English uses contractions like "don't" as a short way of writing two words, such as "do" and "not." In Braille there are many additional contractions....
-
Table of Contents
Assembly Areas F222 Dressing, Fitting, and Locker Rooms F223 Medical Care and Long-Term Care Facilities F224 Transient Lodging Guest Rooms F225 Storage F226 Dining Surfaces...
-
RAMP
A walking surface that has a running slope steeper than one unit vertical in 20 units horizontal (5-percent slope)....
-
11B-502.6.4 Marking
Each accessible car and van space shall have surface identification complying with either Section 11B-502.6.4.1 or 11B-502.6.4.2....
-
F206.8 Security Barriers
Security barriers, including but not limited to, security bollards and security check points, shall not obstruct a required accessible route or accessible means of egress....
-
Advance Notice for Optional Services and Equipment
Equipment Although carriers are not required to provide the following services or equipment, if they choose to provide them, you may require 48 hours’ advance notice and one hour’s advance check-in...
-
206.8 Security Barriers
Security barriers, including but not limited to, security bollards and security check points, shall not obstruct a required accessible route or accessible means of egress....
-
Mirrors: ADA Standard Section 603.3
Section 603.3 covers the current ADA Standards for mirrors in toilet and bathing rooms.
-
11B-603.3 Mirrors
Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1016 mm) maximum above the finish floor or ground....
-
11B-705.1.1.1 Dome size
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (22.9 mm) minimum and 0.92 inch (23.4 mm) maximum, a top diameter of 0.45 inch (11.4 mm) minimum and...
-
Parking sign height measurement technique
502.6 says "Signs shall be 60 inches (1525 mm) minimum above the finish floor or ground surface measured to the bottom of the sign." But which floor or ground surface? ...
-
Size: ADA Standard Section 1008.3.1.1
Transfer platforms shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
Size: ADA Standard Section 1008.3.2.1
Transfer steps shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
11B-1008.3.1.1 Size
Transfer platforms shall have level surfaces 14 inches (356 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
11B-1008.3.2.1 Size
Transfer steps shall have level surfaces 14 inches (356 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
Microsoft Word Accessibility Basics: Webinar Series Archive
July 20th: Accessibility Full Check and Conversion to PDF This webinar will focus on using the Microsoft Word 2016 Accessibility Full Check feature and interpreting the results of the...
-
II. APPLICATION AND PARTIES BOUND
Defendants must promptly notify, in writing, all successors and assigns of the existence of this Consent Decree and its contents. 10....
-
General Tips
Keep a clipboard or other portable writing surface handy for people unable to reach the counter when signing documents....
-
Egress Signage
216.8 Toilet Rooms and Bathing Rooms (from 213.2.2 and 213.2, Exception 4) 216.9 TTYs (from 217.4.9) 216.10 Assistive Listening Systems (from 219.4) 216.11 Check-Out...
-
Introduction and Instructions
Health Plan professionals can use these checklists to check if their policies and procedures, as well as the training they offer is inclusive of these access elements....
-
Height: ADA Standard Section 903.5
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
11B-903.5 Height
The top of the bench seat surface shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the finish floor or ground....
-
11B-813.2.1.1 Size
Adult changing tables shall have a changing surface of 70 inches (1778 mm) minimum length and 30 inches (762 mm) minimum width....
