The accessible portion of the residence extends to those elements used to enter the commercial facility, including the front sidewalk, if any, the door or entryway, and hallways; and those...
Search Results "Door Hardware"
Filters
Commonly Searched Documents
-
11B-245.3 Accessible elements required
-
1009.6.2 Stairway or elevator access
Exception: An interior area of refuge at the level of exit discharge that provides direct access to an exterior exit door....
-
Don-Jo Mfg., Inc. Door Viewers ULDV 180
Number ULDV 180 Dimensions 180 Degrees Ansi L23221 Shelf pack 10 Finishes 605,...
-
Don-Jo Mfg., Inc. Door Viewers DV 180
Number DV 180 Dimensions 180 Degrees Ansi L21371 Shelf pack 10 Finishes 605,...
-
Don-Jo Mfg., Inc. Door Viewers DV 90
Number DV 90 Dimensions 160 Degrees Ansi L21372 Shelf pack 10 Finishes 605,...
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE. ...
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE....
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE....
-
11B-705.2 Detectable directional texture
This surface will be placed directly behind the yellow detectable warning texture specified in Section 11B-705.1.2.1, aligning with all doors of the transit vehicles where passengers will...
-
EXIT
Exit components include exterior exit doors at the level of exit discharge, interior exit stairways and ramps, exit passageways, exterior exit stairways and ramps and horizontal exits....
-
H1
[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
-
Reach Range
The appliance industry called attention to certain types of doors that, when fully open, cannot easily meet this specification, such as dishwasher doors and doors of ovens and broilers that...
-
11B-410.7 Landing size
ETA Editor's Note There are no requirements for landing size in 2010 ADA Standards, although the door maneuvering clearance requirements at 404.2.4 should be applicable outside the platform...
-
4.2.2. High Accessibility Baseline
Percent, ($ millions) Cost Category High Accessibility Baseline Primary Analysis Percent Change Captioning Hardware...
-
4.2.8. Zero Growth After Five Years
Percent, ($ millions) Cost Category Zero Growth After 5 Years Primary Analysis Percent Change Captioning Hardware...
-
Gates
In the proposed rule, section 404 referenced doors and doorways....
-
III-6.1000 General
ILLUSTRATION 2: A doorway is being relocated and a new door will be installed. The new doorway must be wide enough to meet ADAAG....
-
2. Analytical Framework
Section 2.3 shows the methodology used to calculate the upfront costs for movie theaters, including hardware acquisition, device acquisition, and installation costs. ...
-
1133B.2.3.2
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.3.2 Automatic and power-assisted doors. ...
-
Recessed Lavatories
In-swinging doors must clear fixture clearances and door clearances must clear the water closet fixture (verify toilet length)....
-
4.10.12(4)
Controls shall be located on a front wall if cars have center opening doors, and at the side wall or at the front wall next to the door if cars have side opening doors (see Fig. 23(c) and...
-
4.10.12(4)
Controls shall be located on a front wall if cars have center opening doors, and at the side wall or at the front wall next to the door if cars have side opening doors (see Fig. 23(c) and...
-
804.6.2 Operable Parts
Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
-
804.6.2 Operable Parts
Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
