4. Reinforced walls for grab bars. Grab bar reinforcement shall be installed continuous in the walls of showers 32 inches to 38 inches (813 mm to 965 mm) above the floor. The grab...
Search Results "Covered Multifamily Dwelling (FHA)"
Filters
Commonly Searched Documents
-
1134A.6, Item 4
-
1134A.8, Item 4.1
4.1. The space beneath the lavatory shall be left clear and unobstructed;
-
1134A.8, Item 4.2
4.2. Any cabinet beneath the lavatory shall be removable without the use of specialized knowledge or specialized tools; or
-
SECTION 1134A BATHING AND TOILET FACILITIES
[See subsections ...]
-
7(1)(a)
(a) A clear floor space at least 30 inches by 48 inches that allows a parallel approach by a person in a wheelchair is provided at the range or cooktop and sink, and either a...
-
11B-233.3.2 Residential dwelling units for sale
[2010 ADA Standards] 233.3.2 Residential Dwelling Units for Sale....
-
Maneuvering Space at Doors
However, as the Department noted in the preamble to the proposed guidelines, approaches to, and maneuvering spaces at, the exterior side of the entrance door to an individual dwelling unit...
-
7(2)(b)(iv)
(iv) Toilets are located within bathrooms in a manner that permit a grab bar to be installed on one side of the fixture. In locations where toilets are adjacent to walls or bathtubs,...
-
7(2)(a)(ii)
(ii) Clear floor space is provided at fixtures as shown in Fig. 7 (a), (b), (c) and (d). Clear floor space at fixtures may overlap. Fig. 7 Clear Floor Space for...
-
1134A.8 Lavatories, vanities, mirrors and towel fixtures
Water supply and drain pipes under lavatories shall be insulated or otherwise covered to protect against contact. There shall be no sharp or abrasive surfaces under lavatories. 7. ...
-
7(2)(a)
(a) Bathrooms that have reinforced walls for grab bars (see Requirement 6) would meet section 100.205(c)(3)(iv) if: Note: Cabinets under lavatories are acceptable provided the...
-
1134A.8, Item 6
Water supply and drain pipes under lavatories shall be insulated or otherwise covered to protect against contact. There shall be no sharp or abrasive surfaces under lavatories....
-
1134A.8, Item 6
Water supply and drain pipes under lavatories shall be insulated or otherwise covered to protect against contact. There shall be no sharp or abrasive surfaces under lavatories....
-
7(2)(b)(v)
(v) Vanities and lavatories are installed with the centerline of the fixture a minimum of 1'3" horizontally from an adjoining wall or fixture. The top of the fixture rim is a maximum...
-
(5) Reinforced walls for grab bars
The only change made to these guidelines has been to subject powder rooms to the reinforced wall requirement when the powder room is the only toilet facility on the accessible floor of a covered...
-
SECTION 1128A COVERED DWELLING UNITS
SECTION 1128A COVERED DWELLING UNITS...
-
Residential Dwelling Unit
Residential dwelling units do not include transient lodging, inpatient medical care, licensed long-term care, and detention or correctional facilities....
-
RESIDENTIAL DWELLING UNIT
Residential dwelling units do not include transient lodging, inpatient medical care, licensed long-term care, and detention or correctional facilities....
-
1134A.8 Lavatories, vanities, mirrors and towel fixtures
1134A.8 Lavatories, vanities, mirrors and towel fixtures. Bathrooms or powder rooms required to be accessible shall have at least one accessible lavatory. Where mirrors and towel...
-
1134A.6, Item 2
2. Slope. The maximum slope of the shower floor shall be ½ inch (12.7 mm) per foot in any direction and shall slope to a drain. The floor surfaces shall be of Carborundum or...
-
1134A.5, Item 2
2. Reinforced walls for grab bars. A bathtub installed without surrounding walls shall provide reinforced areas for the installation of floor-mounted grab bars. Where a...
-
1134A.6, Item 6
6. Shower controls. Faucet controls and operation mechanisms shall be operable with one hand and shall not require tight grasping, pinching or twisting of the wrist. The force...
-
1134A.6, Item 5
5. Thresholds. When a threshold is used, it shall be a maximum of 2 inches (50.8 mm) in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units...
-
1134A.8, Item 5
5. Finished floor. The finished floor beneath the lavatory shall be extended to the wall.