Housing at a place of education subject to this section shall comply with Sections 11B-224.1 through 11B-224.6 and 11B-806 for transient lodging guest rooms. For the purposes of the...
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
11B-224.7 Housing at a place of education
-
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impact Performance Phase 2: Final Report REPORT PREPARED FOR: U.S ACCESS BOARD, WASHINGTON,...
-
Appendix to May 23, 2014 Document
Clearances within employee work areas) and 405.8 (Handrails within employee work areas). 2010 Standards without these provisions; Note that HUD is permitting use of Section 215.3 (Fire...
-
U.S. Forest Service Accessible Picnic Table Designs - Steel Leg Picnic Table
-
U.S. Forest Service Accessible Picnic Table Designs - Wood Picnic Table
-
U.S. Forest Service Accessible Picnic Table Designs - Stone Leg Picnic Table
-
Pilot Rock Smoker's Cease Fire Ash Receptacle
The Smoker's Cease Fire Ash Receptacle is high density polyethylene with UV protection. The easy open/close lid interlocks with the base. ...
-
Requirement 6. Reinforced walls for grab bars.
Section 100.205(c)(3)(iii) requires that covered multifamily dwellings with a building entrance on an accessible route shall be designed and constructed in such a manner that all premises...
-
Armor-Tile Tactile Systems Surface Applied Systems Installation Video
This is a video demonstrating how to install a single Armor Tile surface-applied tile....
-
The Impact of Transfer Setup on the Performance of Independent Transfers: Phase I Final Report
The Impact of Transfer Setup on the Performance of Independent Transfers: Final Report REPORT PREPARED FOR: U.S. ACCESS BOARD, WASHINGTON, DC Authors: Alicia Koontz, PhD,...
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....
-
B. M301 Diagnostic Equipment Used by Patients in a Supine, Prone, or Side-lying Position and M302 Diagnostic Equipment Used by Patients in a Seated Position
Therefore, the Significant Changes Section addresses the transfer surface and lift compatibility requirements for M301 and M302 together....
-
TownSteel ED1400F Grade 1 Mortise Fire Device
ED1400F is ANSI Certified Grade 1 and UL listed for Fire Hardware. Retrofit 98/99 installation requires no additional door prep. ...
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed transfer surface...
-
1.1.3.2 State-regulated buildings, structures, and applications
Applications regulated by the Office of the State Fire Marshal include, but are not limited to, the following in accordance with Section 1.11. 14.1 Buildings or structures used or intended...
-
1.1.3.2 State-regulated buildings, structures, and applications
State-owned buildings, including buildings constructed by the Trustees of the California State University, and to the extent permitted by California laws, buildings designed and constructed...
-
11B-206.2.3 Multi-story buildings and facilities
The following types of privately funded multistory buildings do not require a ramp or elevator above and below the first floor: 1.1 Multi-storied office buildings (other than the...
-
5.4.1 Transfer Support Location for M301 and M302
Provisions require transfer supports be provided for use with the transfer sides and be located within reach of the transfer surface and not obstruct transfer onto the surface when in position...
-
Section G: Ramps
(§405.7.4) G8 If the rise of the ramp is greater than 6", are handrails provided that are between 34" and 38" above the ramp surface?...
-
Priority 4: Additional Access - Drinking Fountains, Public Telephones & Fire Alarms
Word Fillable Form (0.7MB) Word Non-Fillable Form (0.6MB) PDF Non-Fillable Form (0.4MB)
-
5.4.2 Transfer Support Length for M301 and M302
The purpose of a minimum length is to ensure that there is a minimum gripping surface available to support positioning and repositioning during a transfer....
-
Handrails [§405.8, §505]
Handrail Height and Clearance Handrail Continuity and Extensions Surface requirements and clearances facilitate a power grip along the length of handrails....
-
TotTurf® Synthetic Grass: Play Spaces
Description Tot Turf Play Spaces is a line of natural looking, soft, attenuating turf surfacing perfect for playgrounds....
