Where four or fewer total EVCS are provided, identification with an International Symbol of Accessibility (ISA) and signs identifying van accessible spaces shall not be required....
Search Results "Classroom Space"
Filters
Commonly Searched Documents
-
11B-812.8.1 Four or fewer
-
5.8.2.1 Height of Breast Platform at Time of Measurement
Rationale for the recommendation The shape of the breast platform affects the shape of the knee and toe space....
-
11B-503.5 Vertical clearance
Vehicle pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger drop-off and loading zone and from the passenger drop-off and loading zone to...
-
B. Question 2: Section 904.4.1 and Clear Counter Space
The inquiry into whether a sales or service counter satisfies Section 904.4.1’s length requirement turns on the length of the counter as built, not on the length of “clear” counter space...
-
Additional Clearance: ADA Standard Section 306.2.4
Section 306.2.4 covers the current ADA Standards for additional clearances for toe space.
-
Appendix 3 - Comparison of US Standards to IDEA Center Research
Eye height (EH) 1090-1295 75 1174 1047 1288 Clear Floor Space...
-
Bradley Terreon Classroom Sink TCS Series Plan
Requires the Premium User plan or above. (Login or upgrade your account!) -
703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
3. Exception to Ramp Running Slope
The MDE Advisory Committee, during its discussion of wheelchair spaces on weight scales, extensively addressed the permissible slopes of ramps on raised platforms....
-
4.2 Physical Accessibility Barriers and Solutions
Barriers Solutions Simple/Low cost Involved / High cost Parking spaces are too narrow Use cones and/or tape and temporary signs to mark...
-
11B-609.3 Spacing
The space between the wall and the grab bar shall be 1½ inches (38 mm). The space between the grab bar and projecting objects below and at the ends shall be 1½ inches (38 mm) minimum....
-
703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
Ticketing (Assembly areas, not parking.)
Title II Regulations 28 § 35.138 Ticketing: (a) (1) For the purposes of this section, “accessible seating” is defined as wheelchair spaces and companion seats that comply with...
-
M303.3.3 Ramped (Section-by-Section Analysis)
The MDE NPRM proposed that for equipment with a change in level at the entry of a wheelchair space, level changes greater than ½ inch high would be required to be ramped and comply with...
-
11B-703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
11B-703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
11B-703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
M303.1 General
Diagnostic equipment used by patients seated in a wheelchair shall comply with M303.
-
M303.3.1 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical.
-
M303.3.2 Beveled
Changes in level between ¼ inch (6.4 mm) high and ½ inch (13 mm) high maximum shall be beveled with a slope not steeper than 1:2.
-
M303.4 Components
Where components of diagnostic equipment are used to examine specific body parts, the components shall be capable of examining the body parts of a patient seated in a wheelchair....
