This determination can only be made by the head of the public entity or a designee and must be accompanied by a written statement of the reasons for reaching that conclusion....
Search Results "Head Height"
Commonly Searched Documents
-
Issue: "Grandfather" Clause or Small Entity Exemption
-
1003.3.1 Boat Slip Clearance
All other accessible slips are allowed to have the required pier clearance at the head of the slip....
-
General Tips
Do not patronize people by patting them on the head or shoulder. Treat adults as adults....
-
Introduction
Objects that project into circulation spaces from the side or that do not provide at least 80 inches of head clearance can be extremely hazardous to people who are blind or who have low...
- Cybex Total Access Cable Column Exercise Machine
- GameTime Thread the Needle Playground Equipment
- Inclusion Solutions Poll Star Voting Booth
- Whitehall Mfg. WH2142T2 Ligature Resistant Toilet Top Supply On-Floor Wall Waste
-
2.2 Evidence of Physical Accessibility Barriers
Now I’m shifting so my head is going towards the top of the table. … Now I’m lengthwise, but I’m on my stomach, so I’ve got to turn over.11 Women reported needing assistance getting onto...
-
Section G: Ramps
(§405.3) G3 Is the rise (height) for any ramp run 30" or less?...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
When toilet and bathing facilities have doorway openings instead of doors, such as at airports or stadiums, the geometric identification symbol should be located at the proper height adjacent...
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
1115B.8.4
Toilet tissue dispensers shall be located on the wall within 12 inches (305 mm) of the front edge of the toilet seat, mounted below the grab bar, at a minimum height of 19 inches (485 mm...
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
QUESTION: WHAT CONSTITUTES AN ALTERATION TO A PLATFORM FOR PURPOSES OF TRIGGERING THE APPLICATION OF SECTION 37.42 REQUIREMENTS?
For example, if the platform height relative to the top of rail is raised, if the old surface is removed and/or a new surface put down, or if there is a reconstruction of or structural change...
-
226.1 General
Consider work surfaces that are flexible and permit installation at variable heights and clearances....
-
E. Chapter 4: Boarding and Alighting
the technical requirements for the slope of ramps in non-rail vehicles by specifying a single standard (1:6) for maximum running slope applicable to ramps deployed to roadways or curb-height...
-
4.1.3(17)(a)
At least one public telephone per floor shall meet the requirements for a forward reach telephone3. 1 Additional public telephones may be installed at any height....
-
2.2 Key Measurement Variables and Procedures
Reaches and lifts: One-handed maximum reaches recorded at 5 different heights in three different directions for up to four different weight conditions (maximum of 60 reaches total). 4...
-
Guidelines
Tactile objects are tied closely to the exhibit’s interpretive theme and defy the same standardized approach that can be applied to an exhibit’s mounting height, door size and location,...
-
Communication Access at Doors [§806.3.2, §809.5.5]
They are more effective than locating a regular peephole at a lower height which can impact visual identification of visitors. ...
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height. 3....
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...