It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters. ...
Search Results "Head Height"
Filters
Commonly Searched Documents
-
11B-216.3 Directional and informational signs
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-703.8.5 Character width
TABLE 11B-703.8.5 PIXEL COUNT FOR LOW RESOLUTION VMS CHARACTER HEIGHT CHARACTER WIDTH RANGE STROKE WIDTH RANGE CHARACTER SPACING RANGE...
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters....
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
When toilet and bathing facilities have doorway openings instead of doors, such as at airports or stadiums, the geometric identification symbol should be located at the proper height adjacent...
-
Honeywell SP(W) / SPC Series Indoor Speaker/Strobes
plate tests continuity before installation Automatic selection of 12 or 24 volt operation at 15 and 15/75 candela Ceiling and wall mount application Optional tamper resistant Torx head...
-
PEMKO 5" Latching Panic Saddle Threshold No. 2009-PK
Latching Panic thresholds are supplied predrilled, with #10-24 Phillips, flat head machine screws of appropriate length....
-
NetCentric Technologies Inc. CommonLook PDF GlobalAccess Software
Support for automatic Bookmark-generation (based on heading levels)....
-
HEWI Push/Pull Handle set to EN 179
Push/pull handles are not only suitable as emergency exit devices, they also enable accessible ease of use at a variable gripping height....
-
ICC/IBC: ADA Standard Section 105.2.4
Section 105.2.4 of the ADA Standards cover references to the International Code Council (ICC) and the International Building Code (IBC).
-
Service Counters
If we look at 11B-904.4.1, we see that a 36” minimum long section of the counter needs to be installed at 34” maximum height. ...
-
The Limits of Utilizing a Cost-Benefit Analysis
To our knowledge there are no studies that provide a fully comprehensive analysis of the effects of the height of a transfer surface on people with various disabilities....
-
Jean Tessmer
Some of us prefer to mount to allow 28" knee clearance minimum to give the person in the wheelchair a lower shelf height of 32" depending on the thickness of your new #200 baby changer shelf...
-
5.5(f) The Job Interview
Sources that provide "awareness training," some at little or no cost, may be found under this heading in the Resource Directory Index....
-
Shelves and Maneuvering Space
Items can be placed at any height but staff should be available to assist customers who may have difficulty reaching or viewing items....
-
11B-504.8 Floor identification
11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door on the latch side, in all enclosed stairways in buildings two or more stories in height...
-
Limitations
The decision that a particular aid or service would result in an undue burden must be made by a high level official, no lower than a Department head, and must include a written statement...
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
1003.3.1 Boat Slip Clearance
All other accessible slips are allowed to have the required pier clearance at the head of the slip....
-
11B-1003.3.1 Boat slip clearance
All other accessible slips are allowed to have the required pier clearance at the head of the slip....
-
Section 37.135 Submission of Paratransit Plans
The Department recognizes that it is not reasonable to expect paratransit systems to spring into existence fully formed, like Athena from the head of Zeus....
-
11B-1003.3.1 Boat slip clearance
All other accessible slips are allowed to have the required pier clearance at the head of the slip....
