When play components are located on an accessible route, the height required to transfer directly to the entry point or seat of a play component has a minimum of 11 inches (280 mm) and a...
Search Results "Signage Height"
Commonly Searched Documents
- 
    
  
  Entry Points and Seats
  
 - 
    
  
  704.11.1 Parapet construction
  
The height of the parapet shall not be less than 30 inches (762 mm) above the point where the roof surface and the wall intersect....
 - 
    
  
  1132A.4.1 Thresholds
  
Changes in height at interior door thresholds (e.g., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm)....
 - 
    
  
  Section 4.1.2, Accessible Sites and Exterior Facilities: New Construction (Section-By-Section Analysis and Response to Comments)
  
New Construction (Section-By-Section Analysis and Response to Comments) This section addresses exterior features, elements, or spaces such as parking, portable toilets, and exterior signage...
 - 
    
  
  T304 Operable Parts
  
The technical requirements for operable parts include provisions on height, location, and operation....
 - 
    
  
  Evaluation of transfers
  
to the higher heights (Table 13). ...
 - 
    
  
  Participants
  
A total of 73 participants were enrolled consisting of 56 men and 17 women, with an average age of 45 ± 15 years, body weight of 176 ± 53 lbs and a height of 67±6 in....
 - 
    
  
  § 38.159(c)(5) Slope
  
If the height of the vehicle floor from which the ramp is deployed is 3 inches (75 mm) or less above a 6 inch (150 mm) curb, a maximum slope of 1:4 is permitted; if the height of the vehicle...
 - 
    
  
  1132A.4 Level floor or landing
  
Primary entry doors, required exit doors or secondary exterior doors with changes in height between the interior surface or floor level and the exterior surface or floor level shall comply...
 - 
    
  
  611 Washing Machines and Clothes Dryers
  
Section 611 covers washing machines and clothes dryers and provides specifications for clear floor space, operable parts, and height. Comment....
 - 
    
  
  Clear Floor Space [4.34.2] and Reach Ranges [4.34.3]
  
Maximum reach heights to controls are based on the approach provided. The reach height applies to all controls and elements available for customer activation....
 - 
    
  
  Side Approach
  
Side Approach Where space is provided for a side approach, controls can be mounted at the heights allowed for side reaches....
 - 
    
  
  Lateral grab bar use
  
It can be noted that the lateral grab bar is used by more subjects when the transfer setup increases in level of difficulty (i.e. gap/height in combination or side guard)....
 - 
    
  
  Comparison of Transfer Protocols
  
Highest Transfer Height Obtained Percentiles 5th 25th 50th 75th...
 - 
    
  
  1009.5.4 Transfer Steps
  
Transfer step height shall be 8 inches (205 mm) maximum....
 - 
    
  
  1134A.6, Item 5
  
When a threshold is used, it shall be a maximum of 2 inches (50.8 mm) in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from...
 - 
    
  
  6.9 Tread Obstacles
  
Obstacles on beach access routes and their related resting intervals shall not exceed 1 inch (25 mm) in height measured vertically to the highest point....
 - 
    
  
  1134A.6, Item 5
  
When a threshold is used, it shall be a maximum of 2 inches (50.8 mm) in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from...
 - 
    
  
  11B-809.10.6.5 Thresholds
  
Where provided thresholds shall be 2 inches (51 mm) maximum in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from the horizontal...
 - 
    
  
  J. Valet Parking and New Parking Garage
  
agree to construct accessible parking spaces, entrances, and routes of travel as required by 2010 Standards §§ 208.1, 208.2, 208.2.4, 208.3.1, and 502.1-503.5, and to erect appropriate signage...
 - 
    
  
  11B-411.2.1.6 Identification of floors served
  
elevator banks, each serving a different group of specific floors, hall call consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signage...
 - 
    
  
  904 Sales and Service Counters
  
Specifications are provided for the counter surface height of check-out aisles, including the height of counter edge protection, which is limited to 2 inches above the counter surface (904.3.2...
 - Baby Devoro 1.28 gpf FloWise 10 Inch High Round Front Toilet Designed for children video
 - 
    
  
  General: ADA Standard Section 803.1
  
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....