Eclipse Partitions Eclipse Partitions (patent pending) are the future of restroom partitions that offer both innovative design aesthetics and durable performance. The clean lines...
Search Results "Patient Toilet Room"
Commonly Searched Documents
- Scranton Eclipse Partitions
- ASI Global Partitions Powder Coated Steel Partitions
- Bradley 2-Stall Seat Cover/Tissue Dispenser & Napkin Disposal 5911
-
215.4 Transient Lodging
Guest rooms required to comply with 224.4 shall provide alarms complying with 702....
-
Audio Visual Components
Find out in advance if your facility has any assistive listening systems or devices available, how the meeting room is wired and equipped for sound amplification, and if there are additional...
-
4.1.6(3)(e)(ii)
(ii) Where it is technically infeasible to install a required standard stall (Fig. 30(a)), or where other codes prohibit reduction of the fixture count (i.e., removal of a water...
-
5.3.2.3 Slope
The slope of the turning space and clear floor or ground space surface shall not be steeper than 1:48 (2 percent) in all directions. Exception: When the surface is not paved or is...
-
Avoid the extremes of surface reflectivity and contrast (slides 11 and 13)
Flooring [As shown in slide 11 photo, this room is] fairly successful; [it] could use some tweaking when you look at it from that point of view....
-
A4.17.3 Size and Arrangement
In large toilet rooms, where six or more toilet stalls are provided, it is therefore required that a 36 in (915 mm) wide stall with parallel grab bars be provided in addition to the standard...
-
11B-224.7.1 Multi-bedroom housing units with mobility features
Multi-bedroom housing units containing accessible sleeping rooms with mobility features shall have an accessible route throughout the unit in compliance with Section 11B-809.2....
-
11B-224.7.1 Multi-bedroom housing units with mobility features
Multi-bedroom housing units containing accessible sleeping rooms with mobility features shall have an accessible route throughout the unit in compliance with Section 11B-809.2....
-
11B-224.7.1 Multi-bedroom housing units with mobility features
Multi-bedroom housing units containing accessible sleeping rooms with mobility features shall have an accessible route throughout the unit in compliance with Section 11B-809.2....
-
Bedside Clearance [9.2.2(1)]
Bedside Clearance [9.2.2(1)] Where one bed is provided in a room, maneuvering space at least 36 inches wide is required on both sides of the bed....
-
Minimum Number [9.1.2 and 9.1.3]
Minimum Number [9.1.2 and 9.1.3] The number of accessible rooms required is based on the total number of rooms provided....
-
Number of Accessible Bathrooms
A few commenters recommended that half-baths/powder rooms also be subject to the Act's requirement. Response....
-
M303.3.3.2 Cross Slope
The cross slope of ramp runs shall not be steeper than 1:48.
-
M303.3.3 Ramped
Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.
-
M303.3.3 Ramped (Section-by-Section Analysis)
The MDE NPRM proposed that for equipment with a change in level at the entry of a wheelchair space, level changes greater than ½ inch high would be required to be ramped and comply...
-
5.8.1.2.1 Ramped Entry Slope Recommendations
5.8.1.2.1 Ramped Entry Slope Recommendations The Committee recommends that raised platforms have a ramp with slopes that do not exceed the following: At 0 to 1½ inches, the...
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms.
-
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height. Edge protection is not required on platforms 1 ½ inches or less in height.
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms Recommendations Description: Entry to wheelchair spaces on raised surfaces greater than ¼ inch in height requires a...
-
5.8.1.2.1 Ramped Entry Slope
5.8.1.2.1 Ramped Entry Slope. Raised platforms should have a ramp with slopes that do not exceed the following: Rise 0 to 1 ½ inches – 1:2 Slope Rise >1 ½ to 2 ½ inches – 1:8...