Exceptions: The clear width of accessible routes connecting elevated play components shall be permitted to be reduced to 32 inches (813 mm) minimum for a distance of 24 inches (610 mm) maximum...
Search Results "Maximum Reach Depth"
-
11B-1008.2.4.2 Elevated
-
2.6
with lines of sight comparable to those for members of the general public, (b) including wheelchair spaces as an integral part of the fixed seating plan, (c) providing the appropriate depth...
-
How to Measure Transfer Surface Height
The lower wheelchair illustrates a typical diagonal transfer.24 Figure 11: Corner radii of a medical examination table The depth and width are measured along the centerlines of...
-
Moisture and Durability
The trendline fitted to the data of the moisture profile in E2 indicates that it is saturated at a depth of approximately 100 mm (4”) and continues to be saturated to the drainage bed....
-
M305.2.2 Length (Section-by-Section Analysis)
there was no requirement for length of the transfer support; however, the MDE NPRM preamble noted that the Access Board was considering requiring the transfer supports to extend the entire depth...
-
T402.8 Running Slope
The maximum running slope of ramps and bridgeplates shall comply with T402.8.1 or T402.8.2....
- Georgia-Pacific ® Automated Soap and Sanitizer Dispenser 53010
- Kohler Elevance Rising Wall Alcove Bath
- Georgia-Pacific ® White Automated Soap and Sanitizer Dispenser
- Lynx Grills Inc. 30” Grill ProSear Burner & 1 Stainless Steel Burner (L500ADA)
-
1008.3.2.2 Height
Each transfer step shall be 8 inches (205 mm) high maximum....
-
M303.3.1 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical....
-
405.6 Rise
The rise for any ramp run shall be 30 inches (760 mm) maximum....
-
1008.3.2.2 Height
Each transfer step shall be 8 inches (205 mm) high maximum....
-
405.6 Rise
The rise for any ramp run shall be 30 inches (760 mm) maximum....
-
R407.6.1 Slope
Landing slopes shall be 2 percent maximum in any direction....
-
11B-405.6 Rise
The rise for any ramp run shall be 30 inches (762 mm) maximum....
-
11B-406.5.7 Cross slope
The cross slope of curb ramps and blended transitions shall be 1:48 maximum....
-
11B-1008.3.2.2 Height
Each transfer step shall be 8 inches (203 mm) high maximum....
-
4.28.3(5)
(5) The flash rate shall be a minimum of 1 Hz and a maximum of 3 Hz....
-
M303.3.1 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical....
-
M101.4 Dimensions
Dimensions that are not stated as "maximum" or "minimum" are absolute....
-
11B-406.5.7 Cross slope
The cross slope of curb ramps and blended transitions shall be 1:48 maximum....
-
M101.4 Dimensions
Dimensions that are not stated as “maximum” or “minimum” are absolute....