These technical criteria are available at http://www.access-board.gov/ada-aba/final.cfm#a505 and address continuity, height, clearance, gripping surface, cross section, surfaces, fittings...
Search Results "Height Adjustable"
Commonly Searched Documents
-
Additional Technical Criteria Considered for Handrails on Ramps
-
11B-505.10.3 Bottom extension at stairs
The horizontal extension of a handrail shall be 12 inches (305 mm) long minimum and a height equal to that of the sloping portion of the handrail as measured above the stair nosings....
-
11B-703.8.5 Character width
TABLE 11B-703.8.5 PIXEL COUNT FOR LOW RESOLUTION VMS CHARACTER HEIGHT CHARACTER WIDTH RANGE STROKE WIDTH RANGE CHARACTER SPACING RANGE 7 5-6...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters. ...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-703.8.5 Character width
TABLE 11B-703.8.5 PIXEL COUNT FOR LOW RESOLUTION VMS CHARACTER HEIGHT CHARACTER WIDTH RANGE STROKE WIDTH RANGE CHARACTER SPACING RANGE...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters....
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
When toilet and bathing facilities have doorway openings instead of doors, such as at airports or stadiums, the geometric identification symbol should be located at the proper height adjacent...
-
ICC/IBC: ADA Standard Section 105.2.4
Section 105.2.4 of the ADA Standards cover references to the International Code Council (ICC) and the International Building Code (IBC).
- HEWI Push/Pull Handle set to EN 179
- Cybex Total Access Row/Rear Delt Exercise Machine
- SciFit PRO1000 - Seated Upper Body Machine
-
Service Counters
If we look at 11B-904.4.1, we see that a 36” minimum long section of the counter needs to be installed at 34” maximum height. ...
- Gamco Surface-Mounted Paper Cup Dispenser - CD-1
-
Jean Tessmer
Some of us prefer to mount to allow 28" knee clearance minimum to give the person in the wheelchair a lower shelf height of 32" depending on the thickness of your new #200 baby changer shelf...
-
When is an Employer Obligated to Make a Reasonable Accommodation?
An applicant or employee does not have to specifically request a "reasonable accommodation," but must only let the employer know that some adjustment or change is needed to do a job because...
-
Issue 2: Location relative to the crosswalk
In existing streetscapes, without a median, it may also be possible to widen the crosswalk (and adjust the stop line accordingly) to eliminate the offset. ...
-
Accessible Routes
Operators should adjust the speed to accommodate riders, where necessary....
-
I. Purpose of the Regulatory Action
bus will be able to board the bus even though sidewalk construction or snow prevents the individual from boarding the bus from the bus stop; the operator of the bus will need to slightly adjust...
- Delta Electronic Lavatory NS DEMD-301LF
- Delta Electronic Lav with Mixer NS DEMD-311LF
- San Jamar C4210PRD Pull-Type Paper/Plastic Beverage Cup Dispenser