In § 38.113, amend paragraph (d)(3) by removing the period at the end of the paragraph and adding the words “ensuring compliance with section 37.42, where applicable” in its place....
Search Results "Control End Wall"
Filters
Commonly Searched Documents
-
17. In § 38.113, amend paragraph (d)(3)
-
903.2 Clear Floor or Ground Space
Clear floor or ground space complying with 305 shall be provided and shall be positioned at the end of the bench seat and parallel to the short axis of the bench....
-
Applying Accessibility Guidelines to Your Site
How did we end up with so many accessibility guidelines and standards? Which guidelines and standards apply to your site?...
-
2. Is this trail primarily surfaced with a material other than asphalt, concrete, or boardwalk?
Yes No If “No” is selected, then skip to “End of Survey” (Qualtrics Option). If “Yes is selected, then skip to Question #3....
-
11B-407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with Section 11B-407.4.7.2....
-
Rockwood Manufacturing Company 11047 Series 47 Straight Single Bar Set 8" Pull CTC
Metal: T4 Back to Back and Concealed; Pull Free End = 6, Push Free End = 6, Common End = 5....
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall....
-
Recessed Doors and Gates: ADA Standard Section 404.2.4.3
Section 404.2.4.3 covers the current ADA Standards for maneuvering clearances at recessed doors and gates.
-
Alteration
restoration, resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls...
-
11B-201.3 Temporary and permanent structures
facilities covered by these requirements include, but are not limited to, reviewing stands, temporary classrooms, bleacher areas, stages, platforms and daises, fixed furniture systems, wall...
-
11B-903.6 Structural strength
Benches shall be affixed to the wall or floor....
-
11B-804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware. ◼...
-
SEC. 512. AMENDMENTS TO THE REHABILITATION ACT. 42 USC 12115
.-- Section 7 of the Rehabilitation Act of 1973 (29 U.S.C. 706) is amended by adding at the end the following new paragraph: (22)(A) The term 'drug means a controlled substance, as defined...
-
§ 37.131(a)(2)(ii)
(ii) At end stations and other stations in outlying areas, the entity may designate circles with radii of up to 11/2 miles as part of its service area, based on local circumstances....
-
2010 ADA Standards
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
Kohler Veil™ One-Piece Elongated Dual-Flush Wall-Hung Toilet With Reveal® Quiet-Close™ Seat
Requires the Premium User plan or above. (Login or upgrade your account!) -
30.1 Q. Would it be acceptable to use removable base cabinets beneath a wall-hung lavatory where a parallel approach is not possible?
A. Yes. The space under and around the cabinet should be finished prior to installation. For example, the tile or other floor finish must extend under the removable base cabinet.
-
M301.2.3 Transfer Surface Transfer Sides
The option to transfer will be required only on one long side of the patient scanning/imaging table and not at the “foot” or “head” end of such surfaces....
-
M301.2.3 Size (Section-by-Section Analysis)
discussed in Section IV.B.1.c (Significant Changes – Transfer Surface Size), in the final rule the Access Board has revised this provision to account for the two types of transfer surfaces (end...
-
A.2.ii. - Should EIT be compatible with assistive technology?
These products, such as information kiosks, copiers, or other similar products that do not permit a user to install or connect assistive technology, must be designed so that an end user...
-
Common Problems with Toilet Rooms
Ø The "accessible" toilet is placed too close or too far from the wall or stall divider. ...
-
Section 36.204 Administrative Methods (Section-By-Section Analysis and Response to Comments)
or methods of administration that have the effect of discriminating on the basis of disability or that perpetuate the discrimination of others who are subject to common administrative control...
