Handrails may be located in a recess if the recess is a maximum of 3 in (75 mm) deep and extends at least 18 in (455 mm) above the top of the rail (see Fig. 39(d))....
Search Results "Commuter Rail Car"
Commonly Searched Documents
-
4.26.2* SIZE AND SPACING OF GRAB BARS AND HANDRAILS
-
§ 38.83(a)(1) General
All new light rail vehicles, other than level entry vehicles, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying...
-
B. Restrooms
These specifications are derived from requirements for rail vehicles and represent compromises between space needed for use and constraints imposed by vehicle dimensions....
- Don’t tell me I can’t: disability in a modern world | Cheryl Stowe | TEDxFurmanU
- Rebuilding Together Caroline County - Denton, MD
- Inpro Corporation IPC® HR9 Northern Hardwoods® Real Wood Handrail
-
If a passenger loading area serves cars and vans, as well as buses, must the provisions for passenger loading zones and bus loading zones both be satisfied?
No, provisions for bus loading zones (§810.2) apply only to on-street bus stops and those bus loading zones that exclusively serve designated or specified public transportation...
-
Transit Stops (R308.1) (Section-by-Section Analysis)
Where transit stops serve vehicles with more than one car, boarding and alighting areas serving each car must comply with these requirements....
-
1012.2 Height
Exceptions: For occupancies in Group R-3, and within individual dwelling units in occupancies in Group R-2, both as applicable in Section 101.2, guards whose top rail also serves...
-
Are detectable warnings required on curb ramps or at hazardous vehicular areas?
Under the ADA Standards, which apply primarily to facilities located on sites, detectable warnings are required at transit facilities (at curb ramps and along open drop-offs of rail station...
- seca 664 - electronic wheelchair scale_without comments - seca1840
-
Handrail Requirements
They also would preclude use of panels below handrails, which have become popular in meeting code requirements that prohibit openings in railings through which a 4 inch sphere can pass....
-
Transfer Sides (M301.2.3 and M302.2.3)
The transfer sides are permitted to be obstructed temporarily by features such as armrests, side rails, footrests, and stirrups provided they can be repositioned (e.g., folding armrests,...
- Horton ProSlide™-Blast Sliding Door System
-
Overview of Proposed Guidelines
signals; Pedestrian signals, including requirements for accessible pedestrian signals and pedestrian pushbuttons; Transit stops and transit shelters for buses and light rail...
-
1. Typical Issues
Typical Issues During an evacuation, some individuals with a mobility disability may arrive at the shelter in a car or van....
-
C. Executive Order 13132: Federalism
The 2016 Non-Rail Vehicle Guidelines are issued pursuant to the Americans with Disabilities Act (ADA)....
-
C. Why are Curb Ramps at Pedestrian Crossings Required?
They can either stay at home and not go to their chosen destination, or they can risk their personal safety by using their wheelchairs, scooters, or walkers to travel alongside cars and...
-
703.4.1 Height above Finish Floor or Ground
[ECTCR UFAS 4.30.6] EXCEPTION: Tactile characters for elevator car controls shall not be required to comply with 703.4.1....
-
Temporary Facilities
Access to temporary facilities on a golf course may be achieved through either an accessible route or golf car passage....
-
R309.2 Parallel Parking Spaces
Accessible parallel parking spaces located at the end of the block face are usable by vans that have rear lifts and cars that have scooter platforms....
-
11B-703.5.6 Height from finish floor or ground
Exceptions: Visual characters indicating elevator car controls shall not be required to comply with Section 11B-703.5.6....