Seats shall be mounted securely and shall not slip during use....
Search Results "Ceiling Mounted Patient Lift"
-
4.20.3 SEAT
-
11B-610.4 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Symmons Symmetrix® Two Handle Lavatory Faucet (Centerset) S-250-0-LWG-1.5
Symmons Symmetrix® Two Handle Lavatory Faucet S-250 Series Symmetrix two handle cast brass centerset lavatory faucet 4" mount Ceramic cartridges 1/2" IPS inlet connections standard...
-
Symmons® Allura Two Handle Widespread Lavatory Faucet SLW-4712-1.5-554
Feature Highlights: Two handle widespread lavatory faucet with quarter turn ceramic components 8 - 16 inch centers for mounting Braided supply hoses Pop-up drain and lift rod...
-
M306.1 General (Section-by-Section Analysis)
The MDE NPRM proposed that, where diagnostic equipment communicates instructions or other information to the patient, the instructions or information must be provided in at least two of...
-
Background
Healthcare practitioners find breast-imaging challenging when patients must remain seated in mobility devices such as wheelchairs or scooters for the procedure....
-
Provider knowledge
As we see in Jack’s story above, a provider’s lack of knowledge is one barrier to accessing health care for patients with physical disabilities....
-
AJW Architectural Products U591 1.6 Gallon Sanitary Napkin Disposal - Surface Mounted
Cabinet Back: Stainless steel welded to cabinet body with key hole mounting points....
-
AJW Architectural Products U807 Single Fold Toilet Tissue Dispenser - Surface Mounted
Striker tabs prevents damage to mounting surface when cover is closed. (Unibody design) Cabinet Back: #22 ga stainless steel with embossed towel guides....
-
1134A.7, Item 4
Water closet controls shall be mounted no more than 44 inches (1118 mm) above the floor. The force required to activate controls shall be no greater than 5 pounds (22.2 N)....
-
2. Beds
In some cases, an appropriately mounted grab bar can assist an inmate to transfer between the bed and a wheelchair....
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
K4
If built-in food, drink, condiment, and tableware dispensers are provided, are dispensers and operating controls mounted no higher than 54 inches above the floor if clear floor space is...
-
5e.
Are signs mounted on both sides of the elevator hoistway door opening that designate the floor with 2-inch minimum-height raised letters and Braille characters centered at 60 inches above...
-
4.34.5.5(4) Controls
In the shower stall in Fig. 35(a), all controls, faucets, and the shower unit shall be mounted on the side wall opposite the seat....
-
1132A.10 Door signal devices
The activating mechanism shall be mounted a maximum of 48 inches (1219 mm) above the floor and connected to permanent wiring....
-
1134A.7, Item 4
Water closet controls shall be mounted no more than 44 inches (1118 mm) above the floor. The force required to activate controls shall be no greater than 5 pounds (22.2 N)....
-
11B-609.8 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the grab bar, fastener, mounting device,...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
1132A.10 Door signal devices
The activating mechanism shall be mounted a maximum of 48 inches (1219 mm) above the floor and connected to permanent wiring....
-
AJW Architectural Products US888 Single Security Toilet Tissue Dispenser, Exposed Mounting - Surface Mounted - Non-Controlled
Product Features Fabricated of #18 gauge stainless steel with #4 satin finish Holds one standard toilet tissue roll Accomodates Keyed Padlock To Prevent Theft Unit is...
-
AJW Architectural Products U815 Dual Toilet Tissue Dispenser w/ Mounted Shelf - Surface Mounted - Non-Controlled
Product Features Fabricated of #18 gauge stainless steel with #4 satin finish. Holds one or two standard toilet tissue rolls. Product Specs Shelf: Fabricated of #18 gauge...
-
AJW Architectural Products US889 Dual Security Toilet Tissue Dispenser, Exposed Mounting - Surface Mounted - Non-Controlled
Product Features Fabricated of #18 gauge stainless steel with #4 satin finish Holds one standard toilet tissue roll Accomodates Keyed Padlock To Prevent Theft Unit is...
-
The SmartWheel
The SmartWheel is a wheelchair - mounted device for measuring propulsion parameters that can be used to compute forces, acceleration, rate of rise, velocity, stroke length, and other aspects...
