The 1991 Standards and the 2010 Standards apply to fixed or built-in elements of buildings, structures, site improvements, and pedestrian routes or vehicular ways located on a site....
Search Results "Standard Telephone Keypad"
Commonly Searched Documents
-
§ 36.406(b) Scope of coverage.
-
§ 35.151(d) Scope of coverage.
The 1991 Standards and the 2010 Standards apply to fixed or built-in elements of buildings, structures, site improvements, and pedestrian routes or vehicular ways located on a site....
-
11B-202.3.1 Prohibited reduction in access
If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the number...
-
National Technology Transfer and Advancement Act of 1995
consensus standards bodies, which are private, generally non-profit organizations that develop technical standards or specifications using well-defined procedures that require openness,...
-
National Technology Transfer and Advancement Act of 1995
consensus standards bodies, which are private, generally non-profit organizations that develop technical standards or specifications using well-defined procedures that require openness,...
-
National Technology Transfer and Advancement Act of 1995
or adopted by voluntary consensus standards bodies, which are private, generally non-profit organizations that develop technical standards or specifications using well-defined procedures...
-
National Technology Transfer and Advancement Act of 1995
or adopted by voluntary consensus standards bodies, which are private, generally non-profit organizations that develop technical standards or specifications using well-defined procedures...
-
1.1.3.1 Nonstate-regulated buildings, structures, and applications
Except as modified by local ordinance pursuant to Section 1.1.8, the following standards in the California Code of Regulations, Title 24, Parts 2, 2.5, 3, 4, 5, 6, 9, 10 and 11 shall apply...
-
11B-213.3.3 Urinals
[2010 ADA Standards] 213.3.3 Urinals. Where more than one urinal is provided, at least one shall comply with 605....
-
11B-608.5 Controls
[2010 ADA Standards] 608.5 Controls. Controls, faucets, and shower spray units shall comply with 309.4....
-
11B-407.4.7.1.1 Type
[2010 ADA Standards] 407.4.7.1.1 Type. Control buttons shall be identified by tactile Characters complying with 703.2....
- The Accessibility Management Platform (AMP)
-
Sec. 469.052(b)
(b) The standards and specifications adopted by the commission under this chapter must be consistent in effect with the standards and specifications adopted by the American National Standards...
-
Applying Accessibility Guidelines to Your Site
How did we end up with so many accessibility guidelines and standards? Which guidelines and standards apply to your site?...
-
§ 36.606(d)
(d) When the standards of the Act against which a code is deemed equivalent are substantially revised or amended, a certification of equivalency issued under the preexisting standards is...
-
§ 36.606(d)
(d) When the standards of the Act against which a code is deemed equivalent are revised or amended substantially, a certification of equivalency issued under the preexisting standards is...
-
Introduction
Title II of the Americans with Disabilities Act (ADA), Commonly Asked Questions about the Americans with Disabilities Act and Law Enforcement, Title II Highlights, Access for 9‒1‒1 and Telephone...
-
Electronic and information technology (Preamble, Section-by-Section Analysis)
This is the statutory term for the products covered by the standards in this part....
-
SAFE HARBOR
If an element never complied with the 1991 ADA Standards then there is no safe harbor for that element....
-
11B-410.7 Landing size
ETA Editor's Note There are no requirements for landing size in 2010 ADA Standards, although the door maneuvering clearance requirements at 404.2.4 should be applicable outside the platform...
-
ADA Safe Harbor Provisions
required by the 2010 Standards....
-
1.1 Basis.
This AC is based on federal regulations and standards....
-
Thresholds at Doorways
The 1991 Standards, at section 4.13.8, require the height of thresholds at doorways not to exceed ½ inch and thresholds at exterior sliding doors not to exceed ¾ inch....
-
General Issues
with the Board's standards....